Palsonic VCR9688 owner manual Recording

Page 19

RECORDING

Basic Operation

1. Press the OPERATE/TIMER button.

2. Press the buttons to select a desired channel to be recorded.

3.Insert a cassette tape with a safety tab.

4.Press the REC button to start recording.

5.To finish recording, press the STOP/EJECTbutton.

Checking the Picture Being Recorded

Turn on the TV and tune to the channel for video viewing.

.NotesIf a cassette without a safety tab is inserted, it will automatically eject when the REC button is pressed. This protects the recorded contents on tape against

. accidental erasure.

If the tape reaches its end during recording, it will be automatically rewound to its beginning and the unit

. will be switched to Stop mode.

In the Pause mode, it is possible to change a channel.

Recording One Programme While Viewing Another

1.Press the OPERATE/TIMER button.

2.Set the TV for normal TV viewing and select the channel to be viewed.

3.Select a desired channel to be recorded with the

buttons.

4.Insert a cassette tape with a safety tab.

5.Press the REC button to start recording.

6.To finish recording, press the STOP/EJECT button

Auto Turn on System

When a cassette tape with a safety tab is inserted with the VCR turned off, the VCR will be automatically turned on.

Pause Function

To stop recording momentarily

1.Press the PAUSE button during recording.

2.To release the pause mode and resume recording, press the REC button

REC Review

During normal recording (excluding timer recording and OTR), pressing the PAUSE button causes the VCR to rewind and display the last half second of the recording. This allows you to check a recording while it is being recorded.

Recording from Another VCR

With this VCR, you can make recordings from an external source, e.g. copying onto this VCR from a second VCR.

1.Connect another VCR or an external equipment to this VCR.

2.Press the 0/AUX button twice so that the line input indicator "AU" appears.

3.Play the tape on VCR A for playback and press the REC button on VCR B.

VCR A (another VCR)

VCR B (your VCR)

E- 15

Page 18 Page 20
Image 19
Page 18 Page 20
Contents VCR-9688 How to Use This Manual Remote control unit Front panel Rear panel Multi-display Identification of ControlsMulti-display Remote Control UnitFront Panel Rear PanelMaintain Good Ventilation Contents Introduction Equipment Connection InstallationConnection of VCR and TV Using Audio/Video Connector Power Supply CablePreparations To Execute AMS again after the Initial Setting Initial Setting UpChanging the Language after the Initial Settings Changing the Time after the Initial SettingOn Screen Display OSD Using the Menu ScreenUsing the Mode Screen Menu Screen/Mode ScreenAutomatic Channel Changing Channel PresettingManual Tuning AMS OperationPreperation for G-Code Instant Video Programming Selecting AUX Position Tuning with the V CH V ButtonsTuning with the Number Buttons Remote Control Only Channel SelectionDigital Tracking Control Auto Head CleanerPlayback Basic OperationFrame Advance Special Effect PlaybackSearch Still FrameZero Return Minute SkipBlueback Function Recording Changing OTR Duration One-touch Timer Recording OTRCounter Function Counter DisplayProgramming procedure Programmable Timer RecordingBefore programming Hints on Programming When two programmes overlapExtending the Recording Time Code Instant Video ProgrammingIf the G-Code number is incorrect About Error MessagesOthers Symptom Cause RemedySpecifications General Section Palsonic Customer Service Telephone
Top Page Image Contents