2 | 3 |
| 1 |
Enter two digits for the start hour and two digits for the start | |
minute using the Number buttons 1. As each number is pressed, | |
the cursor will move to the right. When finished, the AM/PM | |
setting will blink. Press the Number 1 button 2 for AM or the | |
Number 2 button 3 for PM; the End Time hour digits will blink. | |
NOTE: You can also use the Navigation (π,†) buttons followed | |
by the Navigation (®) button to select between AM and PM. |
Enter two digits for the end hour and two digits for the end minute using the Number buttons. As each number is pressed, the cursor will move to the right; the Tape Speed option will blink.
NOTE: The AM/PM setting will automatically be set.
3
|
| 1 | |
Press the Navigation ( ) button to cycle through the Tape |
| 2 | |
When finished, press the SETUP button 1 to store the program. | |||
† | |||
Speeds (SP {Slow Play) or SLP {Super Long Play). | Set for another program as desired or press the SKIP n button 2 to | ||
| “Program has been saved" will appear temporarily on screen. | ||
| select another program. | ||
| When finished, press the SETUP button 1 twice to exit the setting. | ||
| Turn the unit off or press the DVD/VCR button (on the main unit) or | ||
| DVD button (on the remote) 3 to switch to DVD mode; the Timer | ||
| indicator will light in the display. When the actual time matches the | ||
| timer On time, the unit will turn on and record as per the program. | ||
| NOTE: | Make sure to have a recordable cassette inserted with | |
NOTES: | enough space/time for the program recording. | ||
|
| ||
• You can change a setting while in the Time mode by using the Navigation (√,®) button to select and then the Number buttons to change. | |||
• You can set up to 8 programs for Timer recording. |
|
| |
• After you have stored the programs, if the program is overlapping (the recording time on the programs set overlap), the PROGRAM | |||
OVERLAP menu will appear on the screen temporarily and Overlap Programs will flash on screen. In this case, you should clear one | |||
program (see below). |
|
| |
TO CLEAR THE TIMER PROGRAM |
|
|
2
1
Enter the VCR mode and the Setup screen as described on page 24; the Setup menu will appear. Scroll to Program Set using the Navigation ( ) button . Press the OK button
to select it; the Program†menu will1appear.2
4
21
Select the program you want to clear using the Skip n 1 or | |
2 button. Then press the COUNTER RESET/CLEAR | |
button 3 to clear the program. When finished, press the | |
26SETUP button 4 twice to exit the VCR setup menu. |