|
|
| Actual Time |
|
| TIMERS |
| ||
|
|
| Programme |
|
|
|
| Start Time |
|
|
|
| Cancel Timer |
|
|
|
|
|
|
English
Display message
Switch the TV to standby.
The message appears on the screen when the TV is switched on again. If you selected Once, the message will disappear from the screen after about 45 seconds.
If you selected Continuous, the message will appear on the screen until the Run menu item in the Message menu is switched to No or until the receiver is powered off.
The message does NOT appear when Continuous subtitles have been switched On. See p. 11.
Timers
With the Timers menu you can make your TV automatically switch to a specific programme number from standby or switch over to a different programme number at a specific time.
Actual time
If you have installed a TV channel which also broadcasts teletext on programme number 1 or under the lowest favourite programme number greater than 1, the time is downloaded from that TV channel. If this is not the case you have to set the time manually with the digit keys. The time, (entered manually) is updated every minute and remains until the TV is switched off with the power off key in the “Power” control panel on the remote control.
Note: If you entered an incorrect digit, complete the actual time with arbitrary numbers, then start again. Use 24 hour, or military time.
Programme
Enter with the digit keys the programme number of the TV channel you want your TV to switch over to. Use 24 hour, or military time.
Start time
Enter with the digit keys the start time of the selected TV programme number you want your TV to switch over to.
Cancel timer
Select Cancel Timer and press OK to reset the Start time to
Keys in front of the receiver box
LOCAL PROGRAM MENU
VOLUME
Should your remote be lost or broken you can still browse through the TV channels and externals or change some of the basic picture and sound settings with the keys in front of the receiver box.
The PROGRAM - and + keys enable you to select the TV channels or externals.
Note: If the message Child Lock ON appears, the child lock must be switched off (with a remote control) before you can use the PROGRAM - and + or the VOLUME - or + keys on the receiver. See p. 15.
Press the LOCAL MENU key behind the door at the front of the receiver repeatedly to select Brightness, Colour or Contrast.
Press the VOLUME - or + key to adjust the chosen selection.
The selected adjustment automatically switches off when after 10 sec. no action has been executed.
Important: although “volume” is stated on the front panel it has no influence on the sound level