Programming levels
The 562V Multimedia Controller allows you to program the level of each analogue source independently, to suit your other equipment, so that when you switch between sources the
The display will show:
Gain
volume stays the same.
You can increase the sensitivity of any source by up to four steps. The loudest source, usually CD, should therefore be chosen as the reference.
The following table shows the correspondence between the gain and sensitivity on the audio inputs:
●Release the Mute key.
The multimedia controller will switch to standby.
●Select the source that sounds loudest and make it your reference.
●Switch to another source in the usual way.
●Use the A and V keys to change the sensitivity.
Gain | 0dB | 2dB | 8dB | 14dB |
|
| |
Sensitivity | 2.5V | 2.0V | 1.0V | 0.5V |
|
| |
For example, the display will show: | 0.5V | ||||||
|
|
|
|
| |||
|
|
|
|
|
|
Configuring the multimedia controller without a computer
32
To balance input levels
●Switch off any power amplifiers that are connected to the multimedia controller.
●Turn off the multimedia controller, using the power switch on the back panel.
●Turn on the power again while holding down the Mute key on the front panel.
The
●Switch between the source you are changing and the reference source until they sound equally loud.
●Repeat the procedure for your other sources.
●When you have finished programming levels, switch the power off and on again to restore normal operation.