Meridian America 562V.2 No lights are displayed when switching on, There is hum on the LP input

Page 53

Troubleshooting

No lights are displayed when switching on

❍Check that your AC power supply is connected correctly.

❍Check that the ON OFF switch on the rear panel is in the ON position.

❍Check that the fuse on the multimedia controller rear panel and the fuse in the unit’s power plug have not blown; see To change the mains fuse, page 50.

There is hum on the LP input

The LP input is the most sensitive input on the multimedia controller.

❍Check that the tone arm is connected to the technical ground of the multimedia controller.

❍Check that the tone arm is connected to the power ground in the turntable.

❍If you are using a magnetic pickup, check that there is not another piece of equipment too near to the turntable or the left-hand side of the multimedia controller. If so, re-position the equipment to cure the problem.

There is hum on other inputs

❍Check your other equipment.

❍Consult your dealer.

48

Image 53

Contents Meridian 562V.2 Multimedia Controller Meridian Multimedia Controller User Guide Sales and service in the USA Contents Troubleshooting Configuring the multimedia controller without a computerConfiguring Multimedia controller Using a computer Introduction Series communications Professional featuresMeridian 500 Series Meridian Digital Music System Sample configurationsMeridian Digital Theatre Specification Specification and accessoriesControl Available accessoriesUsing the multimedia controller Display Front panelTo switch on from standby Switching on and offTo switch to standby Source Label Audio input Input Selecting a sourceLast Valid option To select a sourceTo change the volume Adjusting the volume and changing the displayTo restore the sound To change the displayTo copy a source Recording a sourceUsing the multimedia controller Setting up the multimedia controller Radio interference UnpackingPositioning the multimedia controller Safety warningsTo avoid interference To avoid overheatingDigital audio inputs Connecting the multimedia controllerRear panel Digital connections Digital audio outputsAnalogue audio inputs Analogue audio outputsVideo outputs Analogue connectionsVideo inputs Communications connections Video connectionsTo connect to Meridian DSP loudspeakers Connecting outputsTo connect to a 568 Digital Surround Processor To connect to an analogue source eg Meridian 504 FM Tuner Connecting sourcesTo connect to a LaserDisc player To connect to a DVD player eg Meridian DVD PlayerTo connect to other Meridian 500 Series equipment Connecting to other Meridian EquipmentSetting up the multimedia controller Configuring the multimedia controller without a computer To select a standard setting Choosing standard settings562V Multimedia Controller standard settings To configure a source Configuring the sourcesCdcd CDD1 CDE2 Cdnc CD2A To balance input levels Programming levelsSpecifying information about your system To configure the multimedia controllerConfiguring the multimedia controller without a computer Configuring the multimedia controller using a computer Requirements Meridian Configuration programTo install the Meridian Configuration program Program Running the Meridian Configuration programTo connect the serial cable Creating a new settings file To display or edit the settings To display the settingsTo configure the source options Setting up sourcesTo set up sources Audio Advanced To change the setup options Changing the setup optionsTo store the settings to the 562V Multimedia Controller Completing the configurationTo save the current settings Configuring the multimedia controller using a computer Troubleshooting There is hum on other inputs No lights are displayed when switching onThere is hum on the LP input Troubleshooting Cleaning MaintenanceTo clean the case, display panel, and keypad To clean the audio and video connectionsGuarantee Service and guaranteeService Troubleshooting Index Configuring sourcesInputs Sound Index