Meridian America 562V.2 manual Advanced

Page 48

Each video input option can be set to Last valid to leave the video loop unchanged when you select the source. You would usually do this for audio-only sources, such as CD:

Advanced

Specify the Advanced options as follows:

●If the source is connected to another Meridian unit, set Comms type to 1C for a Meridian CD player, 2C for a Meridian FM tuner, and 3C for a Meridian DVD player. Otherwise set it to None.

●If you have two Meridian source units of the same type you can configure them to have different Comms addresses. You can then select the appropriate source by specifying its Comms address in the Comms address field.

●Select Triggers 1 and/or 2 to switch the corresponding trigger output on when the source is selected.

Trigger 1 is usually selected for all sources, to switch on a power amplifier, and Trigger 2 is usually selected for video sources, to switch a TV.

Configuring the multimedia controller using a computer

43

Image 48

Contents Meridian 562V.2 Multimedia Controller Meridian Multimedia Controller User Guide Sales and service in the USA Contents Configuring the multimedia controller without a computer Configuring Multimedia controller Using a computerTroubleshooting Introduction Professional features Meridian 500 SeriesSeries communications Sample configurations Meridian Digital Music SystemMeridian Digital Theatre Specification and accessories SpecificationAvailable accessories ControlUsing the multimedia controller Front panel DisplaySwitching on and off To switch to standbyTo switch on from standby Selecting a source Source Label Audio input InputTo select a source Last Valid optionAdjusting the volume and changing the display To change the volumeTo restore the sound To change the displayRecording a source To copy a sourceUsing the multimedia controller Setting up the multimedia controller Unpacking Radio interferenceSafety warnings Positioning the multimedia controllerTo avoid interference To avoid overheatingConnecting the multimedia controller Rear panelDigital audio inputs Digital audio outputs Digital connectionsAnalogue audio inputs Analogue audio outputsAnalogue connections Video inputsVideo outputs Video connections Communications connectionsConnecting outputs To connect to a 568 Digital Surround ProcessorTo connect to Meridian DSP loudspeakers Connecting sources To connect to an analogue source eg Meridian 504 FM TunerTo connect to a DVD player eg Meridian DVD Player To connect to a LaserDisc playerConnecting to other Meridian Equipment To connect to other Meridian 500 Series equipmentSetting up the multimedia controller Configuring the multimedia controller without a computer Choosing standard settings To select a standard setting562V Multimedia Controller standard settings Configuring the sources To configure a sourceCdcd CDD1 CDE2 Cdnc CD2A Programming levels To balance input levelsTo configure the multimedia controller Specifying information about your systemConfiguring the multimedia controller without a computer Configuring the multimedia controller using a computer Meridian Configuration program To install the Meridian Configuration programRequirements Running the Meridian Configuration program ProgramTo connect the serial cable Creating a new settings file To display the settings To display or edit the settingsSetting up sources To set up sourcesTo configure the source options Audio Advanced Changing the setup options To change the setup optionsCompleting the configuration To save the current settingsTo store the settings to the 562V Multimedia Controller Configuring the multimedia controller using a computer Troubleshooting No lights are displayed when switching on There is hum on the LP inputThere is hum on other inputs Troubleshooting Maintenance CleaningTo clean the case, display panel, and keypad To clean the audio and video connectionsService and guarantee ServiceGuarantee Troubleshooting Configuring sources IndexInputs Sound Index