Meridian America 562V.2 manual Configuring the sources, To configure a source

Configuring the sources

Configuring the multimedia controller without a computer

30

When the multimedia controller is set to one of the standard settings the 12 source selection keys on the remote select the standard labels and inputs, as shown in the table on page 29.

If the configuration you want is not catered for by one of the standard settings, you can configure each source individually.

The 562V Multimedia Controller provides 12 sources corresponding to the 12 source selection keys on the remote:

CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, DVD, VCR1, VCR2, and LD.

For each source you can configure:

❍The label used for it on the front panel display, from a range of alternative labels.

❍The audio input it selects.

❍The comms type and address, to identify other Meridian 500 Series equipment.

❍The composite video and S-video inputs it selects.

The options are summarised in the table shown on page 31.

To configure a source

●Turn off the multimedia controller, using the power switch on the back panel.

●Turn on the power again while holding down the Display key on the front panel until the display shows Conf.

●Press Source until the left-hand pair of characters identifies the source you want to configure.

For example, to configure the CD	CDCD
source the display initially shows:

●Press Copy (front panel), or > and < (remote), to step between options.

The right-hand pair of characters shows the current value of the option.

●Press A or V to change the value of the option.

When you have finished programming sources:

●Switch off at the back panel, and then switch on again to restore normal operation.