ZyXEL Communications MES-2110 manual 114, Storm Control Configuration, Storm Control Status

Chapter 14 Broadcast Storm Control

The following table describes the labels in this screen.

Table 39 Configuration > Storm Control

LABEL	DESCRIPTION
Storm Control Configuration
Port Number	Use this to select a port number.
Mode	Select the Broadcast, Multicast or DLF mode from the list.
Rate Level	Select a rate range from the list. Options are: 64K~960K (64+),
	1M~100M (1M+), 110M~1000M (10M+).
Rate Limit	Specify specify how many frames the port receives per second. The unit
	changes depending on how you configure in the Rate Level field. The
	value you enter in this field must be within the rate level range.
Active	Use this to enable or disable storm control.
Undo	Click this to restore your last saved settings.
Apply	Click Apply to save your changes to the MES-2110’s run-time memory.
	The MES-2110 loses these changes if it is turned off or loses power, so
	use the Save Settings link in the navigation panel to save your changes
	to the non-volatile memory when you are done configuring.
Storm Control Status
Port	This is the port number.
Broadcast	This is the broadcast frame limit on the port.
Limit
Active	This shows whether broadcast control is enabled or disabled on the port.
Multicast Limit	This is the multicast frame limit on the port.
Active	This shows whether multicast control is enabled or disabled on the port.
DLF Limit	This is the Destination Lookup Failure (DLF) frame limit on the port.
Active	This shows whether DLF control is enabled or disabled on the port.

114

MES-2110 User’s Guide