ZyXEL Communications MES-2110 manual Host DoS Protection, 174, Test

Chapter 22 Mgmt Config and System Restart Menu

Table 71 Mgmt Config > Host Denial-of-Service Protection

LABEL	DESCRIPTION
CableLength	This shows the length of the cable connected to the port.
TEST	Click this to run the test again.

22.8 The Host DoS Protection

You can specify a group of one or more “trusted computers” from which an administrator may use a service to manage the MES-2110. When you turn on this feature, only the trusted IP addresses listed in this screen can use remote management to access the MES-2110. Click Mgmt Config > Host Denial-of- Service Protection to open the following screen.

Figure 88 Mgmt Config > Host Denial-of-Service Protection

The following table describes the labels in this screen.

Table 72 Mgmt Config > Host Denial-of-Service Protection

LABEL	DESCRIPTION
Protection	Use this to enable or disable host denial-of-service protection.
IP Address	Configure the IP address of the trusted computer from which you
	can manage this MES-2110.
	The MES-2110 checks if the client IP address of a computer
	requesting a service or protocol matches the range set here. The
	MES-2110 immediately disconnects the session if it does not
	match.
Enable/Disable	Select Enable to activate this secured client set.
	Select Disable if you wish to temporarily disable the set without
	deleting it.
Undo	Click this to restore your last saved settings.
Apply	Click Apply to save your changes to the ZyXEL Device’s run-time
	memory. The ZyXEL Device loses these changes if it is turned off
	or loses power, so use the Save Settings link in the navigation
	panel to save your changes to the non-volatile memory.

174

MES-2110 User’s Guide