ZyXEL Communications MES-2110 manual MVR Mode, 195, MVR-Configuration Mode Commands

Chapter 23 Command Line Interface

23.8 MVR Mode

This is an ancillary mode of Configuration mode. You must be in Configuration mode for these commands to work.

When in MVR-Configuration mode, the command prompt is as follows:.

MES-2110(config-mvr)#

The following is a list of available MVR-Configuration mode commands:

Note: These commands only apply to the MVR ID specified when you enter MVR- Configuration mode.

Table 81 MVR-Configuration Mode Commands

COMMAND	DESCRIPTION
mvr <1-4094>	Enters MVR (multicast VLAN relay) configuration
	mode for the specified MVR, creating the MVR if
	necessary.

	Note: You must be in Configuration mode for
	this command to work.
group <group-id> <start-address> <n>	Sets the multicast group range for the current
	MVR group.
	group-id: Enter 1-255 characters for the group
	identification.
	start-address: Enter the start IP address for
	the multicast range of this group.
	n: Enter the number of additional addresses to
	generate based on the start address for the
	multicast range of this group.
inactive	Disables the MVR settings for the current MVR
	group.
no inactive	Enables the ‘no’ settings for the current MVR
	group.
no receiver-port <port-list>	Disables the receiver port(s) for the current MVR
	group.
no source-port <port-list>	Disables the source port(s) for the current MVR
	group.
no tagged <port-list>	Sets the untag port numbers for the current MVR
	group.
no group <crgroup-id>	Removes all or specified MVR group settings for
	the current MVR group.
	cr: Leave this field blank and press [Enter].
	group-id: Enter the group ID to remove.

MES-2110 User’s Guide

195