Chapter 23 Command Line Interface

23.7 Configuration Mode

When in Configuration mode, the command prompt is as follows:.

MES-2110(config)#

There are 3 additional ancillary available while in Configuration mode. They are:

Table 79 Basic Commands

ANCILLARY

TRIGGER

DESCRIPTION

MVR

While in Configuration mode:

This mode allows to configure the MES-2110’s

 

Type mvr <1-4094>(where 1-4094)

MVR IDs and their associated options.

 

 

 

is the MVR ID ranging from 1 to

See Section 23.8 on page 195 for details.

 

4094) at the command line prompt

 

 

and then press [ENTER].

 

 

If no MVR exists, then this creates

 

 

one for you.

 

 

 

 

VLAN

While in Configuration mode:

This mode allows you to configure the MES-

 

Type vlan <1-4094>(where 1-4094

2110’s VLAN IDs and their associated options.

 

See Section 23.9 on page 197 for details.

 

is a VLAN ID ranging from 1 to 4094)

 

at the command line prompt and

 

 

then press [ENTER].

 

 

If no VLAN ID exists, then this

 

 

creates one for you.

 

 

 

 

Interface

While in Configuration mode:

This mode allows you to configure the MES-

 

Type interface <port> (where port

2110’s port interfaces and their associated

 

options.

 

is a port number) at the command

 

 

line prompt and then press [ENTER]

See Section 23.10 on page 198 for details.

The following is a list of baseline Configuration mode commands:

Table 80 Configuration Mode Commands

COMMAND

DESCRIPTION

configure terminal

Toggles the Configuration mode, but only if you

 

are first in Privileged mode.

 

 

abnormal detection <enabledisable>

Enables or disables abnormal traffic detection.

abnormal duration <1-60>

Sets the abnormal traffic detection duration in

 

seconds (1-60).

 

 

abnormal interval <1-600>

Sets the protection interval in seconds (1-600).

abnormal permanently <yesno>

Blocks any port permanently when abnormal

 

traffic is detected and this option is set to yes.

abnormal threshold <2000-20000>

Sets the threshold of traffic detection in packets

 

per second (2000-20,000).

 

 

186

MES-2110 User’s Guide

Page 186
Image 186
ZyXEL Communications MES-2110 manual 186, Configuration Mode Commands, Ancillary Trigger Description