ZyXEL Communications MES-2110 manual Link Aggregation Control Protocol, 120, Lacp

Chapter 16 Link Aggregation

The following table describes the labels in this screen.

Table 43 Configuration > Trunk Config > Aggregator Setting

LABEL	DESCRIPTION
Group	This is the trunk group index number.
	The MES-2110 supports up to four trunk groups for 100Mbps ports and up
	to two trunk groups for Gigabit ports. 100Mbps ports and Gigabit ports
	cannot be in the same group.
Members	Select the port(s) that belong to a trunk group.
	For Groups 1 to 4, you can select up to four port members for each group.
	For Group 5, you can select the two Gigabit ports as the members.
LACP	Use this to enable or disable LACP port trunking.
Undo	Click this to restore your last saved settings.
Apply	Click Apply to save your changes to the MES-2110’s run-time memory. The
	MES-2110 loses these changes if it is turned off or loses power, so use the
	Save Settings link in the navigation panel to save your changes to the
	non-volatile memory when you are done configuring.

16.5 Link Aggregation Control Protocol

Click Configuration > Trunk Config > LACP Configuration to display the screen shown next. See Section 16.2 on page 117 for more information on dynamic link aggregation.

Figure 52 Configuration > Trunk Config > LACP Configuration

The following table describes the labels in this screen.

Table 44 Configuration > Trunk Config > LACP Configuration

LABEL	DESCRIPTION
Port State	Select the port to enable Link Aggregation Control Protocol (LACP).
Activity
Hash-mode	Use this to specify the outgoing traffic distribution type.
	Select Lookup to distribute frames based on the destination MAC address.
	Select Xor to distribute frames based on the last 3 bits of the source MAC
	address and the trunk mask load balancing table.

120

MES-2110 User’s Guide