Chapter 16 Link Aggregation

 

Table 44

Configuration > Trunk Config > LACP Configuration (continued)

 

LABEL

 

DESCRIPTION

 

System

 

LACP system priority is a number between 1 and 65535. The switch with

 

Priority

 

the lowest system priority (and lowest port number if system priority is the

 

 

 

same) becomes the LACP “server”. The LACP “server” controls the

 

 

 

operation of LACP setup. Enter a number to set the priority of an active port

 

 

 

using Link Aggregation Control Protocol (LACP). The smaller the number,

 

 

 

the higher the priority level.

 

 

 

 

 

Undo

 

Click this to restore your last saved settings.

 

 

 

 

 

Apply

 

Click Apply to save your changes to the MES-2110’s run-time memory. The

 

 

 

MES-2110 loses these changes if it is turned off or loses power, so use the

 

 

 

Save Settings link in the navigation panel to save your changes to the

 

 

 

non-volatile memory when you are done configuring.

 

 

 

 

16.6 LACP Link Status

Click Configuration > Trunk Config > LACP Link Status in the navigation panel to open the following screen.

Figure 53 Configuration > Trunk Config > LACP Link Status

The following table describes the labels in this screen.

Table 45 Configuration > Trunk Config > LACP Link Status

LABEL

DESCRIPTION

Actor

This is the local MES-2110.

 

 

MAC

This is the local MES-2110’s MAC address.

 

 

Priority

This is the local MES-2110’s priority level.

 

 

Port ID

This shows the port number belonging to the trunk group.

 

 

Key

This is the local MES-2110’s key value.

 

 

Priority

This is the port priority level.

 

 

Partner

This is the peer MES-2110.

 

 

MAC

This is the peer MES-2110’s MAC address.

 

 

Priority

This is the peer MES-2110’s priority level.

 

 

Port ID

This shows the port number belonging to the trunk group.

 

 

MES-2110 User’s Guide

121

Page 121
Image 121
ZyXEL Communications MES-2110 manual Lacp Link Status, 121, Mac