Chapter 10 802.1x

10.3 802.1x Radius Server Configuration Screen

Use this screen to configure the RADIUS server settings.

Click Configuration > 802.1x > Radius Server Configuration in the navigation panel to display the screen as shown.

Figure 33 Configuration > Radius Server Configuration

The following table describes the labels in this screen.

Table 16 Configuration > Radius Server Configuration

LABEL

DESCRIPTION

Server IP

Enter the IP address of the external authentication server in dotted

Address

decimal notation.

 

 

Server

Enter a password (up to 128 alphanumeric characters) as the key to be

Shared Key

shared between the external authentication server and the MES-2110.

 

The key must be the same on the external authentication server and your

 

MES-2110. The key is not sent over the network.

 

 

Server UDP

Enter the port number of the RADIUS server. The default port number is

Port Number

1812.

 

 

Server

Enter the port number of the external accounting server. The default port

Accounting

number is 1813. You need not change this value unless your network

Port Number

administrator instructs you to do so with additional information.

 

 

Server Time

Type how many minutes a session can be left idle before the session

Out

times out.

 

 

Undo

Click this to restore your last saved settings.

 

 

Apply

Click Apply to save your changes to the MES-2110’s run-time memory.

 

The MES-2110 loses these changes if it is turned off or loses power, so

 

use the Save Settings link in the navigation panel to save your changes

 

to the non-volatile memory when you are done configuring.

 

 

80

MES-2110 User’s Guide

Page 80
Image 80
ZyXEL Communications MES-2110 manual 10.3 802.1x Radius Server Configuration Screen, Server UDP, Port Number 1812 Server