ZyXEL Communications MES-2110 manual 202, Port, the port must allow frames

Chapter 23 Command Line Interface

Table 83 Interface Mode Commands

COMMAND	DESCRIPTION
storm-control broadcast-limit [cr	Sets the broadcast storm control for the current
<lowmediumhigh> <rate>]	port(s).
	cr: Enter nothing for this field and just press
	[Enter] to enable broadcast packet limits on the
	current port(s).
	low: 64K~960K (64..960) in 64k steps.
	medium: 1~100M (1..100) in 1M steps.
	high: 100~1000M (110..1000) in 10M steps.
storm-control multicast-limit [cr	Sets the multicast storm control for the current
<lowmediumhigh> <rate>]	port(s).
	cr: Enter nothing for this field and just press
	[Enter] to enable multicast packet limits on the
	current port(s).
	low: 64K~960K (64..960) in 64k steps.
	medium: 1~100M (1..100) in 1M steps.
	high: 100~1000M (110..1000) in 10M steps.
storm-control dlf [cr <lowmediumhigh>	Sets the DLF storm control for the current
<rate>]	port(s).
	cr: Enter nothing for this field and just press
	[Enter] to enable DLF packet limits on the
	current port(s).
	low: 64K~960K (64..960) in 64k steps.
	medium: 1~100M (1..100) in 1M steps.
	high: 100~1000M (110..1000) in 10M steps.
vid-pri-overide <enabledisable>	Enables or disables the VLAN ID priority override
	for the current port(s).
vlan-stacking role <normalaccesstunnel>	Sets the VLAN stacking port roles of the current
	port(s.)
	normal: The device ignores frames received (or
	transmitted) on this port with VLAN stacking
	tags.
	access: The device adds the SP TPID tag to all
	incoming frames received on this port.
	tunnel: Use this for egress ports at the edge of
	the service provider's network.
	Note: In order to support VLAN stacking on a
	port, the port must allow frames of 1526
	bytes (1522 bytes + 4 bytes for the
	second tag) to pass through it.

202

MES-2110 User’s Guide