ZyXEL Communications MES-2110 manual 199, Interface Mode Commands

Chapter 23 Command Line Interface

Note: These commands only apply to the ports specified when you enter Interface Configuration mode.

Table 83 Interface Mode Commands

COMMAND	DESCRIPTION
interface port-channel <port-list>	Enters Interface Configuration mode for the
	specified port(s).
abnormal-detection-enable	Enables port detection for the current port(s).
active	Enables the current port(s).
arp-inspection-trust	Enables ARP inspection trust for the current
	port(s). When enabled, the device does not
	discard ARP packets on trusted ports.
auto-negotiation	Enables auto-negotiation for the current port(s).
bandwidth-limit egress <cr>	Sets the egress rate for the current port(s).
<lowmediumhigh> <rate>	cr: Press [ENTER] without entering any other
	parameters to enable egress bandwidth control
	on the current port(s).
	low: 64K~960K (64..960) in 64k steps.
	medium: 1~100M (1..100) in 1M steps.
	high: 100~1000M (110..1000) in 10M steps.
bandwidth-limit ingress <lowmediumhigh>	Sets the ingress rate for the current port(s).
<rate>	cr: Press [ENTER] without entering any other
	parameters to enable egress bandwidth control
	on the current port(s).
	low: 64K~960K (64..960) in 64k steps.
	medium: 1~100M (1..100) in 1M steps.
	high: 100~1000M (110..1000) in 10M steps.
bpdu-mode <onofftunnel>	Sets the BPDU packet process mode for the
	current port(s).
da-pri-override <enabledisable>	Sets the destination MAC priority override for the
	current port(s).
dhcp snooping trust	Sets DHCP snooping trust for the current port(s).
	Trusted ports are connected to DHCP servers or
	other switches, and the device discards DHCP
	packets from trusted ports only if the rate at
	which DHCP packets arrive is too high.
egress-set <port-list>	Sets the outgoing traffic port list for a port-base
	VLAN for the current port(s).
flow-control	Enables interface flow control for the current
	port(s).

MES-2110 User’s Guide

199