Chapter 3 Hardware Overview

3Pull the transceiver out of the slot.

Figure 12 Removing the Fiber Optic Cables

Figure 13 Opening the Transceiver’s Latch Example

Figure 14 Transceiver Removal Example

3.2Power Connections Overview

Use the following procedures to connect the MES-2110 to a power source after you have installed it.

Note: Check the power supply requirements in Chapter 25 on page 215, and make sure you are using an appropriate power source.

Keep the power supply switch and the MES-2110’s power switch in the OFF position until you come to the procedure for turning on the power.

Use only power wires of the required diameter for connecting the MES- 2110 to a power supply.

MES-2110 User’s Guide

33

Page 33
Image 33
ZyXEL Communications MES-2110 manual Power Connections Overview, Removing the Fiber Optic Cables