ZyXEL Communications MES-2110 manual 112

Chapter 13 Bandwidth Control

The following table describes the related labels in this screen.

Table 38 Configuration > Bandwidth Control

LABEL	DESCRIPTION
Bandwidth Control Configuration
Port Number	Use this to select a port number.
Mode	This shows the Ingress (incoming) or Egress (outgoing) mode.
Rate Level	Select a rate range from the list. Options are: 64K~960K (64+), 1M~100M
	(1M+), 110M~1000M (10M+).
Rate Limit	Specify the maximum bandwidth allowed for the traffic flow on a port. The
	unit changes depending on how you configure in the Rate Level field. The
	value you enter in this field must be within the rate level range.
Active	Use this to enable or disable bandwidth control.
Undo	Click this to restore your last saved settings.
Apply	Click Apply to save your changes to the MES-2110’s run-time memory.
	The MES-2110 loses these changes if it is turned off or loses power, so use
	the Save Settings link in the navigation panel to save your changes to the
	non-volatile memory when you are done configuring.
Bandwidth Control Status
Port	This is the port number.
Ingress Limit	This is the ingress rate limit on the port.
Active	This shows whether bandwidth control for ingress traffic is enabled or
	disabled on the port.
Egress Limit	This is the egress rate limit on the port.
Active	This shows whether bandwidth control for egress traffic is enabled or
	disabled on the port.

112

MES-2110 User’s Guide