ZyXEL Communications MES-2110 manual 159

Chapter 21 QoS

Table 60 Configuration > QoS Menu > Base Configuration

LABEL	DESCRIPTION
Port	This label shows the port you are configuring.
Priority Mode	Select a priority mode for the port.
	802.1p Priority uses port priority as queuing basis. Assign a
	priority level to each port in the 802.1p Priority screen (Section
	21.3 on page 160).
	Tag Priority uses VLAN tag priority as queuing basis. See
	Section 21.4 on page 161 for more details on configuring tag
	priority.
	IP ToS Priority uses IP DSCP priority as queuing basis. See
	Section 21.5 on page 161 for more details on configuring IP DSCP
	priority.
	IP & Tag Priority uses both IP DSCP priority and tag priority as
	queuing basis.
IP Over Tag	Use this to enable or disable IP Over Tag on the port.
	When you enable this feature and the MES-2110 receives a frame
	containing both IP DSCP and tag priority information, the MES-
	2110 will only use the IP DSCP priority information.
All Port	Use this to set the priority mode for all ports.
Undo	Click this to load your last saved settings.
Apply	Click Apply to save your changes to the ZyXEL Device’s run-time
	memory. The ZyXEL Device loses these changes if it is turned off
	or loses power, so use the Save Settings link in the navigation
	panel to save your changes to the non-volatile memory.
QoS Base Status
Port1-10	This is the port number.
Schedule	This is the schedule mode used on the MES-2110.
Priority Mode	This is the priority mode used on the port.
IP Over Tag	This shows whether the IP over tag feature is enabled or disabled
	on the MES-2110.

MES-2110 User’s Guide

159