ZyXEL Communications MES-2110 manual Interface Mode, Vlan ID Priority Example, 198

Chapter 23 Command Line Interface

23.9.1 VLAN ID Priority Example

This example assigns port 1 as a tagged port for VLAN 1 and sets the priority of all incoming packets from VLAN 1 to priority 3.

MES-2110> enable

MES-2110# configure terminal

MES-2110(config)# vlan 1

MES-2110(config-vlan)# tagging 1

MES-2110(config-vlan)# vid-priority 3

MES-2110(config-vlan)# use-vid-priority yes

MES-2110(config-vlan)# exit

MES-2110(config)# interface port-channel 1

MES-2110(config-interface)# vid-pri-override enable

MES-2110(config-interface)# exit

MES-2110(config)# exit

MES-2110# show priority-override

port	vid-pri-override		da-pri-override	sa-pri-override
=================================================================
01	enabled		disabled	disabled
02	disabled		disabled	disabled
03	disabled		disabled	disabled
04	disabled		disabled	disabled
05	disabled		disabled	disabled
06	disabled		disabled	disabled
07	disabled		disabled	disabled
08	disabled		disabled	disabled
09	disabled		disabled	disabled
10	disabled		disabled	disabled
MES-2110# show vlan tag-base vlan-table
No.	VLAN-ID	Priority	Pri-override	1 (M:member, U:untag)
				1234567890 (T:tag, -:nomember)
=========================================================
1	1	3	Yes	TUUUUUUUUU
2	24	0	No	----------

MES-2110#

23.10 Interface Mode

This is an ancillary mode of Configuration mode. You must be in Configuration mode for these commands to work.

When in Interface-Configuration mode, the command prompt is as follows:.

MES-2110(config-interface)#

198

MES-2110 User’s Guide