WebView Switches
Switch Conf. (Configuration) Tab - Bridge Multicast
The Bridge Multicast screen displays the ports and LAGs attached to the Multicast service group. The Port and LAG tables reflect the manner in which the port or LAG joined the Multicast group. Ports can be added either to existing groups or to new Multicast service groups.
From this screen, you can view the VLAN ID for each of the Switch’s ports. Where many ports are present, you can scroll to the right on the screen to view the settings for further ports.
Enable Bridge Multicast Filtering. Indicates if bridge Multicast filtering is enabled. If Multicast filtering is disabled, Multicast frames are flooded to all ports in the relevant VLAN. This is disabled by default.
VLAN ID. Identifies a VLAN and contains information about the Multicast group address.
Bridge Multicast Address. Identifies the Multicast group IP or MAC address.
Ports. Displays Port that can be added to a Multicast service.
LAGs. Displays LAGs that can be added to a Multicast service.
The table on this screen displays the IGMP port and LAG members management settings:
•D - The Port/LAG has joined the multicast group dynamically,
•S - Attaches the port to the Multicast group as a static member.
•F - Forbidden ports, which are not included in the multicast group, even if IGMP snooping designated the port to join a multicast group.
•Blank - The port/LAG is not attached to a multicast group.
To add a multicast group, use the Add Multicast Group screen, by clicking the Add icon at the end of the row.
Chapter 5: Using the
Figure
Figure
35
Switch Conf. (Configuration) Tab - Bridge Multicast
