Iomega EP510 manual AIR Connections Supply, Output, Gauge, Contents, Supply Pressure Requirements

M-4109/1104 IP510, EP510, IP511, EP511 SERIES A

AIR CONNECTIONS

SUPPLY

Connect air supply to 1/4 NPT port marked "IN." If the above specifications are not met, possibility of internal clogging exists. Also see MAINTENANCE section.

OUTPUT

Connect output to 1/4 NPT port marked "OUT."

GAUGE

The plugged 1/8 NPT port in the base of the transducer is internally connected with the "OUT" port. A pressure gauge can be attached to this port to monitor output pressure.

	CONTENTS
	Air Connections	. . . .Page 1
	Pressure Requirements	. . . .Page 2
	Mounting	. . . .Page 2
	Direct Mounting
	Mounting Kits
	Electrical Connections	. . . .Page 3
	Precautions to be observed during installation
	Calibration	. . . .Page 4
	Maintenance	. . . .Page 5
	Agency Approvals, Special Notes, and Cautions	.Page 5 & 6
	Kits	. . . .Page 7
	Specifications	. . . .Page 8
WARNING

In order to get optimal service from this transducer and ensure warranty coverage the following MUST be followed:

•The supply air quality to this instrument must be instrument quality air as defined by ISA Standard 57.0.01-1996.

1.Dew point not higher than 35˚F.

2.No particulates larger than 3 microns in size.

3.Maximum oil content of 1 ppm.

•No mechanical adjustments or calibrations are necessary or allowed. All calibration MUST be done with electrical poten- tiometers on the enclosed circuit board only. See “CALIBRATION” section of instructions for more information.

TABLE 1: SUPPLY PRESSURE REQUIREMENTS

Standard Output	0-2	0-5	0-30	0-60	0-100	0-120	1-17	3-9	3-15	3-27	6-30
Calibration	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI
Transducer	20-45	20-45	50-90	80-120	110-130	130-140	30-70	20-100	20-100	35-100	35-100
Supply Pressure	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI	PSI

3