Iomega EP510 manual Series I/P and E/P Transducer Specifications

AM-4109/1104 IP510, EP510, IP511, EP511 SERIES

510 and 511 Series I/P AND E/P TRANSDUCER SPECIFICATIONS

Accuracy:	± 0.10% of output span, typical
	± 0.25% of output span, maximum
Hysteresis:	0.01% of output span, typical
	0.10% of output span, maximum
Dead Band:	Not measurable
Repeatability:	0.01% of output span, typical
	0.10% of output span, maximum
Ambient Temperature Effect	± 0.004% of nominal span per ˚F, typical
	± 0.022% of nominal span per ˚F, maximum
Zero:
Span:	± 0.013% of calibrated span per ˚F, typical
	± 0.022% of calibrated span per ˚F, maximum
Compensated Temperature Range:	+32˚F to +122˚F
Operating Temperature Range	-20˚F to 160˚F
Buna-N elastomers:
	0˚F to 160˚F
Viton elastomers:
Storage Temperature Range	-40˚F to 200˚F
Buna-N elastomers:
	-15˚F to 200˚F
Viton elastomers:
Vibration Effect:	Less than 0.5% of SPAN per 1G,
	5-2000 Hz, 3G maximum, 3 axes
Mounting Position Effect:	Not measurable
Loop Load, I/P transducer:	Less than 10 VDC drop at 20 mA
	Less than 12 VDC drop at 50 mA
Supply Voltage, E/P Transducer	9 VDC to 28 VDC, less than 20 mA
Intrinsically Safe/Nonincendive:
	9 VDC to 40 VDC, less than 20 mA
General Purpose:
Supply Voltage Effect:	Not measurable
Signal Impedance, E/P Transducer:	6000 Ohm minimum
RFI/EMI Effect (NEMA 4X):	Less than 0.25% of SPAN, 10V/meter, 20-1000 MHz.
Supply Pressure Requirements:	See TABLE 1
Supply Pressure Effect:	Not measurable
Air Consumption:	6.0 SCFH maximum
Forward Flow Capacity (Supply):	Standard Range 7 SCFM
	Extended Range (over 30 PSI) 12 SCFM
Port Sizes:	Pneumatic: 1/4" NPT
	Electrical: 1/2" NPT

10