FUNAI MWR10D6 Installing batteries in the remote control, Using a remote control, Display menu

Page 13

Before you start

Functional overview (cont’d)

Before

Installing batteries in the remote control

Install two “AAA” size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23 feet (7m)

30°

Remote 30° control

you start Connections Getting started Recording Playing discs

Guide to Displays on screen menu

This unit uses the following on screen menu for most operations: Setup menu and Title list, and Display menu. They allow you to change the playing status of the disc during playback.

The Display menu also gives you information on the status of the disc.

DISPLAY menu

Editing

Press [DISPLAY] to call up the Display menu. This menu will give you the information on the playing disc. Some operations are available while disc is playing.

 

4

 

1

 

1

1

0:00:00

DVD+RW

 

 

 

CH

2

 

5

 

2

 

 

 

HQ(1Hr)

 

1:01

6

 

 

3

 

1.Indicates a disc type and a format mode (Format mode is displayed with DVD-RW/DVD-R (Video mode) disc inserted). NOTE: In some descriptions on this manual, only one disc type is indicated as an example.

2.Indicates a channel number.

3.Indicates a recording mode and possible recording time left.

4.Indicates a title number, chapter number and the time lapse of disc play.

5.Each icon means:

: Search

: Audio

: Subtitle

: Angle

: Repeat

: Marker

: Noise Reduction

: Zoom

: Surround

6.Indicates current disc status.

Changing the Setup menu Others

Español

EN 11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Press STANDBY-ON to turn the unit on Input Mode Names for Common TV BrandsBox or Is a trademark of DVD Format/Logo Licensing CorporationTimer Recording is now set Turn off the unit to set the Timer Standby modeDisc Size Recording Video/Sound Mode Time Quality After all recordings, finalize your discBefore you start Connections Getting started Changing the Setup menu OthersRecording Playing discs Editing Laser Safety PrecautionsBefore you start Make your contribution to the environmentBefore you Precautions cont’dSupplied Accessory Installation LocationAvoid the Hazards of Electrical Shock and Fire Moisture Condensation WarningWith an AM radio MaintenanceDolby Digital Recording Others EspañolTable of contents Symbol Description FeaturesChanging the Setup menu Others Español Connections Getting started Recording Playing discs EditingFunctional overview Front Panel Indicator GuideFront Panel Functional overview cont’d Changing the Editing Setup menu Others EspañolRear Panel Remote Control Using a remote control Installing batteries in the remote controlDisplay menu Guide to Displays on screen menuSetup menus Connection to a TV ConnectionsThis unit 14 EN Connection to a cable box or satellite boxInput jacks Connection to an Audio SystemInput jack Easy DVD recording Getting startedThis unit can record on the following type of discs This operation may take a while to be recognizedChannel Disc Easy DVD recording cont’dChannel setting Initial settingGetting channels automatically Adding/deleting channels Channel setting cont’dRequired Settings menu will appear Press Setup Using K / L, select Required Settings. Press OKUsing K / L, select TV Audio Select. Press OK Selecting the TV stereo or SAPAuto Clock Setting Setting the clockPress Setup Using K / L, select Clock. Press OK Press Setup to exit Press STANDBY-ON to turn off the unitManual Clock Setting Setting the clock cont’dBefore Selecting the TV aspect ratioYou start ConnectionsRecording Recording modeInformation on DVD recording InformationDVD+RW ᵫᵿᶉᶃᴾᵣᶂᶇᶒᶑᴾᵡᶍᶋᶎᵿᶒᶇᶀᶊᶃᵈ Information on DVD recording cont’dBefore recording Setting for Auto ChapterReplacing disc menu Basic recording Changing the Setup menuPress OPEN/CLOSE a Playing discsRefer to Recording mode on One-touch Timer RecordingTurn on the unit and load a recordable disc Make sure that the TV input is set on the unitTimer Recording Timer REC indicator will be off Timer Recording cont’dPriority of overlapped settings Hints for Timer RecordingBefore you start Connections Getting started Recording Overwriting from the beginning of the title Overwriting an existing titleOverwriting in the middle of the title Hints for Overwriting Overwriting an existing title cont’dBefore you start Using K / L, select E2 Front. Press OK Settings for an external sourceUsing K / L, select E1 Rear. Press OK Connection to an external sourceSetting a disc to protect Settings for an external source cont’dChanging Editing Setup menu Recording from an external sourceUsing K / L, select Finalize. Press OK Press Setup Using K / L, select Disc Edit. Press OKPlaying the discs in other DVD players Finalizing a discAuto finalizing Playing the discs in other DVD players cont’dStart Connections Information on DVD play Playing discsGuide to displays Basic playback Using K / L, select a desired title. Press OKPlayback Press Stop C to stop play- backPlaying MP3 disc Basic playback cont’dPress Play B to start play- back Stop mode, press Title to call up the MP3 menuPlaying discs using the title menu Playing discs using the disc menuPause BeforeyouSkipping TV commercials during play Fast forward / Fast reverseX40 Rapid play Special playback cont’dStep by step playback Slow forward / Slow reverse playZoom Marker SetupUsing Display Using Prev H / Next GSearch Title/Chapter searchSearch cont’d Using / B, select Press OKTrack search Time searchRepeat playback Repeat/Random/Program playbackAll TrackRepeat/Random/Program playback cont’d Switching subtitlesSelecting the format of audio and video Program playbackSwitching virtual surround system Switching audio soundtrackSelecting the format of audio and video cont’d Start Connections Getting started Recording PlayingUsing K / L, select a desired option. Press OK Switching camera anglesReducing block noise Editing Editing discs Setup menuInformation on disc editing Guide to a title listEditing discs Using K / L, select Edit. Press OKDeleting titles This operation may take a while to be completedUsing K / L, select Yes Press OK Using K / L, select Edit Title Name. Press OKPutting names on titles After this operation is completed Press Return to exitEditing discs cont’d Setting chapter marksClearing chapter marks Clearing chapter marks cont’d Using K / L, select Delete All. Press OKTo delete all chapter marks Before you start Connections GettingHiding chapters Using K / L, select Current Chapter. Press OK56 EN Using K / L, select Index Picture.Press OK Setting pictures for thumbnailsSetup menu Changing Others Start Connections GettingDividing a title Putting name on disc Editing discs Setup menuSetting or releasing disc protect Editing discs Setup menu cont’dUsing K / L, select Disc Protect OFF ON. Press OK 60 ENReleasing disc from protect Setting or releasing disc protect cont’dErasing disc Using K / L, select Make Edits Compatible. Press OKMaking edits compatible Tour of the Setup menu Changing the Setup menuLanguage setting Display setting Language setting cont’dChanging the Editing Setup menu Others Recording Playing DiscsAudio setting Display setting cont’dWhen playing disc with copyright protection Audio setting cont’dDynamic Range Control Default on Using K / L, select a settingProgressive Scan Default OFF Video settingYes Settings for Parental lock levelConnections Getting started Recording Playing Discs EditingSettings for PBC Playback Control Settings for Parental lock level cont’dChange the password PBC Video CD only Default onSymptom Remedy TroubleshootingOthers Recording/Timer Recording/Editing Symptom Remedy PlaybackOthers Troubleshooting cont’d74 EN Language codeGlossary Frequently Asked Questions76 EN SpecificationsFácil grabación de DVD EspañolNota Puede elegir entre distintos tipos de discos DVD grabablesSugerencia 2 Edite el disco grabado Sugerencia 1 Reproduzca el contenido grabado¿Qué son títulos y capítulos? Finalización de un discoMemo Tel Customer ServiceVan Ness Avenue, Torrance, CA
Top Page Image Contents