FUNAI MWR10D6 owner manual Before you start, Precautions, Laser Safety

Page 4

Before you start

Precautions

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magni- tude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and mainte- nance (servicing) instructions in the literature accompanying the appliance.

Laser Safety

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modi- fications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthor- ized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residen- tial installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION:POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

A NOTE ABOUT RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemi- cal wastes.

Make your contribution to the environment!!!

•Used up batteries do not belong in the dust bin.

•You can dispose of them at a collection point for used up batteries or special waste. Contact your council for details.

For Customer Use:

Read carefully the information located at the back of this unit and enter below the Model No. and Serial No. Retain this information for future reference.

Model No. _____________________

Serial No. _____________________

EN

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Input Mode Names for Common TV Brands Press STANDBY-ON to turn the unit onBox or Is a trademark of DVD Format/Logo Licensing CorporationTurn off the unit to set the Timer Standby mode Timer Recording is now setDisc Size Recording Video/Sound Mode Time Quality After all recordings, finalize your discBefore you start Connections Getting started Changing the Setup menu OthersRecording Playing discs Editing Precautions Laser SafetyBefore you start Make your contribution to the environmentPrecautions cont’d Before youInstallation Location Supplied AccessoryAvoid the Hazards of Electrical Shock and Fire Moisture Condensation WarningMaintenance With an AM radioDolby Digital Recording Others EspañolTable of contents Features Symbol DescriptionChanging the Setup menu Others Español Connections Getting started Recording Playing discs EditingFunctional overview Front Panel Indicator GuideFront Panel Functional overview cont’d Changing the Editing Setup menu Others EspañolRear Panel Remote Control Installing batteries in the remote control Using a remote controlDisplay menu Guide to Displays on screen menuSetup menus Connection to a TV ConnectionsThis unit Connection to a cable box or satellite box 14 ENInput jacks Connection to an Audio SystemInput jack Getting started Easy DVD recordingThis unit can record on the following type of discs This operation may take a while to be recognizedEasy DVD recording cont’d Channel DiscChannel setting Initial settingGetting channels automatically Channel setting cont’d Adding/deleting channelsPress Setup Using K / L, select Required Settings. Press OK Required Settings menu will appearUsing K / L, select TV Audio Select. Press OK Selecting the TV stereo or SAPSetting the clock Auto Clock SettingPress Setup Using K / L, select Clock. Press OK Press Setup to exit Press STANDBY-ON to turn off the unitSetting the clock cont’d Manual Clock SettingSelecting the TV aspect ratio BeforeYou start ConnectionsRecording mode RecordingInformation on DVD recording InformationInformation on DVD recording cont’d DVD+RW ᵫᵿᶉᶃᴾᵣᶂᶇᶒᶑᴾᵡᶍᶋᶎᵿᶒᶇᶀᶊᶃᵈBefore recording Setting for Auto ChapterReplacing disc menu Changing the Setup menu Basic recordingPress OPEN/CLOSE a Playing discsOne-touch Timer Recording Refer to Recording mode onTurn on the unit and load a recordable disc Make sure that the TV input is set on the unitTimer Recording Timer Recording cont’d Timer REC indicator will be offPriority of overlapped settings Hints for Timer RecordingBefore you start Connections Getting started Recording Overwriting from the beginning of the title Overwriting an existing titleOverwriting in the middle of the title Hints for Overwriting Overwriting an existing title cont’dBefore you start Settings for an external source Using K / L, select E2 Front. Press OKUsing K / L, select E1 Rear. Press OK Connection to an external sourceSettings for an external source cont’d Setting a disc to protectChanging Editing Setup menu Recording from an external sourcePress Setup Using K / L, select Disc Edit. Press OK Using K / L, select Finalize. Press OKPlaying the discs in other DVD players Finalizing a discAuto finalizing Playing the discs in other DVD players cont’dStart Connections Information on DVD play Playing discsGuide to displays Using K / L, select a desired title. Press OK Basic playbackPlayback Press Stop C to stop play- backBasic playback cont’d Playing MP3 discPress Play B to start play- back Stop mode, press Title to call up the MP3 menuPlaying discs using the disc menu Playing discs using the title menuPause BeforeyouSkipping TV commercials during play Fast forward / Fast reverseX40 Special playback cont’d Rapid playStep by step playback Slow forward / Slow reverse playMarker Setup ZoomUsing Prev H / Next G Using DisplaySearch Title/Chapter searchUsing / B, select Press OK Search cont’dTrack search Time searchRepeat/Random/Program playback Repeat playbackAll TrackSwitching subtitles Repeat/Random/Program playback cont’dSelecting the format of audio and video Program playbackSwitching audio soundtrack Switching virtual surround systemSelecting the format of audio and video cont’d Start Connections Getting started Recording PlayingUsing K / L, select a desired option. Press OK Switching camera anglesReducing block noise Editing discs Setup menu EditingInformation on disc editing Guide to a title listUsing K / L, select Edit. Press OK Editing discsDeleting titles This operation may take a while to be completedUsing K / L, select Edit Title Name. Press OK Using K / L, select Yes Press OKPutting names on titles After this operation is completed Press Return to exitEditing discs cont’d Setting chapter marksClearing chapter marks Using K / L, select Delete All. Press OK Clearing chapter marks cont’dTo delete all chapter marks Before you start Connections GettingHiding chapters Using K / L, select Current Chapter. Press OK56 EN Setting pictures for thumbnails Using K / L, select Index Picture.Press OKSetup menu Changing Others Start Connections GettingDividing a title Editing discs Setup menu Putting name on discEditing discs Setup menu cont’d Setting or releasing disc protectUsing K / L, select Disc Protect OFF ON. Press OK 60 ENSetting or releasing disc protect cont’d Releasing disc from protectErasing disc Using K / L, select Make Edits Compatible. Press OKMaking edits compatible Changing the Setup menu Tour of the Setup menuLanguage setting Language setting cont’d Display settingChanging the Editing Setup menu Others Recording Playing DiscsDisplay setting cont’d Audio settingAudio setting cont’d When playing disc with copyright protectionDynamic Range Control Default on Using K / L, select a settingVideo setting Progressive Scan Default OFFSettings for Parental lock level YesConnections Getting started Recording Playing Discs EditingSettings for Parental lock level cont’d Settings for PBC Playback ControlChange the password PBC Video CD only Default onSymptom Remedy TroubleshootingOthers Symptom Remedy Playback Recording/Timer Recording/EditingTroubleshooting cont’d OthersLanguage code 74 ENFrequently Asked Questions GlossarySpecifications 76 ENEspañol Fácil grabación de DVDNota Puede elegir entre distintos tipos de discos DVD grabablesSugerencia 1 Reproduzca el contenido grabado Sugerencia 2 Edite el disco grabado¿Qué son títulos y capítulos? Finalización de un discoMemo Tel Customer ServiceVan Ness Avenue, Torrance, CA
Top Page Image Contents