Parts and their functions
DCLK: Down-conversion link
This is used to decide whether to go with the down- conversion system control based on the AUX external input or set the
UCLK: Up-conversion link
This is used to decide whether to go with the up- conversion system control that is linked to the down- conversion system or set the
PATHO: Pathological pattern output
This is used to forcibly output the pathological pattern.
SET: Color bar setup setting
This is used to set the color bar setup.
SD14: HD SD14 output selection
This is used to set the HD SD14 output of the CCU as the PM or normal output.
MSEL: Monitor switch selection setting
This is used to set the monitor switch selection to PM, WFM or the
MLINK: Shading link setting
This is used to set whether to link the monitor when the R, B or G shading switch has been selected.
ANLG: CCU analog output setting
This is used to set the analog output of the CCU to the HD or SD component.
O_SEL: Output select
This is used to set the analog output of the CCU to RGB or YPbPr.
SYNC: Sync waveform addition setting
This is used to select whether to add the sync waveform to the analog output.
TYPE: Analog sync phase coarse adjustment
This is used to set the sync waveform to be added to the HD analog output to binary or
H_CO (HDTV): Horizontal sync signal phase coarse adjustment
This is used to coarsely adjust the phase in relation to the HDTV genlock sync signal.
H_FIN (HDTV): Horizontal sync signal phase fine adjustment
This is used to finely adjust the phase in relation to the HDTV genlock sync signal.
H_CO (SDTV): Horizontal sync signal phase coarse adjustment
This is used to coarsely adjust the phase in relation to the SDTV genlock sync signal.
H_FIN (SDTV): Horizontal sync signal phase fine adjustment
This is used to finely adjust the phase in relation to the SDTV genlock sync signal.
SCCO (SDTV): Subcarrier phase coarse adjustment
This is used to coarsely adjust the phase of the subcarrier signal in relation to the SDTV genlock sync signal.
SCFIN (SDTV): Subcarrier phase fine adjustment
This is used to finely adjust the phase of the subcarrier signal in relation to the SDTV genlock sync signal.
SH_H: SD/HD horizontal phase
This is used to adjust the horizontal phase of the SDTV output and HDTV output.
SH_V: SD/HD vertical phase
This is used to set the vertical phase of the SDTV output and HDTV output to line 0 and line 90 (advanced by 90H for HDTV).
VER: ROP software version
This indicates the software version of this unit.
@FUNC control switch
ALC | SPED | WNDW | PEAK |
0 | 0 | 1 | 4 |
POWER SPEED (FAN)
ON LOW
AUTO SETUP MODE
OUTSIDE FULL
MPED FSEL 3% FCTRY BRIGHT CONT
230
DTL CAMNO ON 1
BUZZ | BLACK (PAINT) |
SD | FLR |
<CARD> MODE | EXE |
ALC: Auto iris level
This is used to adjust the auto iris level of the lens.
SPED: Auto iris speed
This is used to set the feedback speed of the auto iris.
WNDW: Auto iris window
This is used to set the image detection area window of the auto iris.
PEAK: Peak/average setting
This is used to set the ratio between the average and peak values of the auto iris image detection.
12