Power indicator is | The Ethernet cable may not be connected properly to the unit's | |
on; Data indicator | Ethernet port. Check this connection on both units. | |
is off |
| |
|
| |
Data light blinking | This is normal. It means the units are transferring/receiving data. | |
|
| |
Power indicator | Make sure both units are plugged directly into unswitched, non- | |
on; Link and Data | GFI outlets. Do not plug them into a surge protector. | |
indicators don’t | The units may be too far from each other. Try moving them to | |
light | ||
outlets that are closer together. | ||
| ||
|
| |
Power, Link, and | Make sure your TV is on. | |
Data indicators on; | Make sure your TV is switched to the correct input for the HDP50. | |
no video or audio | ||
Check the Ethernet connection between the HDP50 unit and your | ||
on display | ||
| TV. Make sure both ends are firmly connected. | |
| Try a different Ethernet cable. | |
|
| |
Power, Link, and | The units may be too far from each other. Try moving them to | |
Data indicators on; | outlets that are closer together | |
frozen or no video |
| |
on display |
| |
|
| |
Static/Interference | Move units away from halogen lamps, light dimmers, and surge | |
| ||
|
|
Specifications
PHY Rate | 200Mbps |
Effect Data Rate | TCP: Up to 75 Mbps effective throughput |
| UDP: Up to 90 Mbps effective throughput |
Frequency Band | 2~28 MHz (With Mask) |
Access Methods | CSMA/CA |
Qos | |
| segment bursting |
| |
| QoS Classification by destination MAC address and IP Port |
Modulation | OFDM (QAM 8/16/64/256/1024, QPSK, BPSK, ROBO) |
Standards | IEEE 802.3, IEEE 802.3U, HomePlug AV1.1 |
Nodes | Up to 63 slaves with 1 master, 64 total devices |
| 4 overlapping networks for neighbor networks with CCo |
| failover |
| Up to 4 masters with up to 252 slaves, 256 total devices in |
| 4 AVLNs |
| Max 64 bridged devices per station |
| Up to 4096 addressable devices including bridged devices |
6