12Using External Equipment
Switching the optical audio signal type
Set up for the DIGITAL AUDIO output terminal (OPTICAL), according to your AV receiver’s operating instructions.
1Press HOME MENU.
2Select “Option”. (
/
then ENTER)
3Select “Digital Audio Out”. (
/
then ENTER)
4Select “Dolby Digital” or “PCM”. (
/
then ENTER)
ItemDescription
Dolby Digital Dolby Digital: outputs in the Dolby Digital format
(factory default) PCM: outputs in the PCM format
PCM | Always outputs in the PCM format regardless of the |
| types of signals |
|
|
5Press HOME MENU again to exit the menu.
Watching an image from a computer
Connecting a personal computer
Use the PC terminals to connect a personal computer (PC).
NOTE
•The PC input terminals are
•Ability to use Plug & Play depends on the computer.
Plasma Display (rear view)
Viewed from the bottom
of the Plasma Display
RGB cable (sold separately)
AV cable with a mini plug (sold separately)
(for PC audio connection)
Personal Computer
70
Displaying an image from a PC
When connected to a PC, the input signal type is automatically identified. If the image from the PC does not come in clearly, you may need to use Auto Setup. See page 62.
To watch an image coming from the PC, press PC on the remote control or press INPUT on the Plasma Display to select “PC”.
NOTE
•The PC terminals are for PC use only. Do not connect audio/ visual equipment to PC terminals.
Signal names for
5 4 3 2 1
10 | 9 | 8 | 7 | 6 |
15 | 14 | 13 | 12 | 11 |
(front view)
Pin No. | Signal name |
|
|
1R
2G
3B
4Not connected
5Not connected
6GND (ground)
7GND (ground)
8GND (ground)
9+5V
10GND (ground)
11Not connected
12SDA
13HD
14VD
15SCL
NOTE
•An Apple® Macintosh® adaptor may be required for use with some Macintosh computers.
En