RCA G32705 manual Unpack the TV, Connect Your TV, TV only, Cables

SETUP AND CONNECTIONS

STEP 1: UNPACK THE TV

Make sure to locate the remote control.

STEP 2: CONNECT YOUR TV

There are three types of connections outlined in this section:

TV Only:	If you’re only going to connect the
	TV to your home antenna or cable
	system.
The Basic Connection:	If you’re going to connect the TV to a
	VCR or satellite receiver.
Advanced Connections:	If you’re going to make multiple
	connections, hooking up the TV to a
	VCR and a satellite receiver.

Cable information and illustrations are given for each type of connection. Once you have completed your desired connection you may skip forward to Step 3.

TV ONLY

This is a basic connection from an antenna or cable system to your TV. Connect the cable into the Cable/Antenna jack as shown.

Cables

You will use the following cable to make your connection:

Coaxial Cable: These cables carry audio and video signals to the TV from an antenna, cable, or cable box.

CABLE, CABLE BOX, OR ANTENNA

TV
	SPEAKER	+ RIGHT -	+ LEFT -
	SELECTION
	EXTERNAL INTERNAL
	SPEAKERS
	INPUT 2		S-VIDEO
INPUT 1	VIDEO	L—AUDIO—R
VIDEO			G-LINK
R	R
AUDIO	AUDIO		CABLE/
L	L		ANTENNA
			INPUT
S-VIDEO	AUDIO OUTPUT

Once you have completed this connection you may skip to Step 3.

Important Stand Information

CAUTION: Choose the location for your TV carefully. Take precautions that the stand or other furniture on which the TV is placed is properly located (see Important Safeguards sheet) and of adequate size and strength to prevent the TV from accidentally being tipped over, pushed off, or pulled off. This could cause damage to the TV and/or personal injury.

Before You Connect

Protect against power surges:

•Connect all components before plugging any power cords into the wall outlet.

•Turn off the TV and/or component before connecting or disconnecting any cables.

•Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV.

4