Mounting the Mast on Brick or Poured Concrete
Mounting the Mast on Brick or
Poured Concrete
Materials Needed | Tools Needed | |
| • | Electric drill with |
|
| 1/2" masonry bit |
| • | Bubble level |
4 double expansion anchors | • | Screwdriver |
| • Hammer | |
| • 7/16" wrench | |
| • | Pencil |
4 machine screws
4 5/16" washers
IMPORTANT Considerations
•The wall anchors used must have a strength of at least 300 pounds of
•Do NOT mount the dish under an eave or overhang that may block or partially shadow the dish.
Mounting Instructions
1.Hold the mounting foot in position on the mounting surface.
2.If you are mounting on a vertical or sloped surface, use a level to ensure that the center line is vertical.
| level on center |
| line of template |
| Level |
| Not Level |
Step 1: Hold the mounting | Step 2: Make sure the mounting |
foot in position. | foot is level. |
3.Mark the four outside holes on the mounting foot.
4.Remove the foot and drill four (4) 1/2" holes in the locations you marked.
DANGER
AVOID Power Lines!
When following these instructions, take extreme care to avoid contact with overhead power lines, electric lights, and power circuits. Contact with power lines, electric lights, or power circuits may be fatal. It is recommended that the dish be located more than 20 feet from overhead power lines.
Mounting the Mast 19