RCA Satellite TV Antenna manual Final Dish Assembly, Leveling Front-to-Back

Final Dish Assembly

Leveling Front-to-Back

1.Loosen the two bolts securing the mast to the mounting foot so the mast moves freely.

2.Place a bubble level on the mast as shown in the figure. Move the mast so the bubble is centered in the level’s window.

Level Not Level Level Not Level

Rotate mast as needed

Adjustment

Rotate mast as needed

Adjustment

Step 2: Verify that the mast is level front-to-back.

3. Tighten the two bolts securing the mast to the mounting foot.

Final Dish Assembly

1. Place the dish-LNB arm assembly on top of the mast (or pole).

Step 1: Place the dish assembly	Sony Step 1: Loosen the mast clamp and lower
on the mast or pole	reflector onto the mast. Tighten the
	clamp screws.

2.Find the length of RG-6 coaxial cable with messenger (ground) wire that will extend from the satellite dish to the cable’s point of entry into the building.

If your total RG-6 coaxial cable length from the dish to the receiver is more than 112 feet, you may need an additional installation component, such as a line amplifier, to compensate for the longer cable length.

Final Installation 29