Panasonic E50 manual Remote Setting, Use 3, 4 10 to select the Settings tab and press 2 or 1

Remote Setting

Preparation

≥Switch [DVD, TV] (15) to “DVD”.

≥Press [FUNCTIONS] (11) to show the FUNCTIONS window.

1Use [3, 4, 2, 1] (10) to select “SETUP” and press [ENTER] (10).

≥The SETUP screen appears.

	DVD-RAM
FUNCTIONS	Disc Protection		Off	Off
	Cartridge Protection
N
S			N
			S
	DISC INFORMATION	DIRECT NAVIGATOR CREATE PLAY LIST
SELECT	TIMER RECORDING			PLAY	PLAY LIST
ENTER
RETURN	SETUP			TOP PLAY	FLEXIBLE REC

2Use [3, 4] (10) to select the “Settings” tab and press [2] or [1] (10).

SETUP	Remote	DVD 1
	Clock
Tuning	Owner ID
Settings	Shipping Condition
Disc
Picture
Sound
Display	Tab	SELECT
Connection		RETURN

3Use [3, 4] (10) to select “Remote” and press [ENTER] (10).

4Use [3, 4] (10) to select “DVD 1”, “DVD 2” or “DVD 3” and press [ENTER] (10).

≥DVD 1:

Select this setting on both the unit and the remote control for normal use with one unit.

≥DVD 2/DVD 3:

Select this setting on both the unit and the remote control when using this unit and another Panasonic unit in the same place. This ensures that you can operate both units independently with their respective remote control.

It also allows you to operate both units with a single remote control, simply by changing the remote control mode on the remote control.

5To change the remote control mode on the remote control itself, press [ENTER] (10) and the numeric buttons (4) corresponding to the code you want to set, [1], [2], or [3], at the same time.

6Press [RETURN] (23).

Changing the unit’s settings (continued)

Operating other Panasonic DVD equipment with the remote control

By changing the remote control code, you can operate other DVD Recorders and players manufactured by Panasonic.

Most of the DVD Recorders and players manufactured by Panasonic use the same system for their remote controls, so if you operate them in the same place, the controls can be confused by the different pieces of equipment. Use the following procedure to change the remote control code to solve this problem.

≥Use “1”, the factory set code, under normal circumstances.

Preparation

≥Switch [DVD, TV] (15) to “DVD”.

Press [ENTER] (10) and the numeric buttons (4) corresponding to the code you want to set, [1], [2], or [3], at the same time.

Note

≥Be sure to set the same remote control code on the main unit as you did for the remote control itself (page 59, “Settings” — “Remote”).

≥The following display appears on the unit’s display if its code and the remote control’s code are different. Change the remote control’s code to suit the unit.

The unit’s remote control code

≥The display disappears after about 5 seconds.

63