Panasonic E50 manual Troubleshooting guide, Play, Remote control

Troubleshooting guide (continued)

Play

Play fails to start even when [1]

(21)is pressed.

Play starts but then stops immediately.

“NO READ”, “UN SUPPORT”, “NO DISC” or “NO PLAY” appears on the unit’s display.

No response when buttons pressed.

A title or chapter doesn’t play when it is selected.

Picture distorted during search.

Alternative soundtrack and subtitles cannot be selected.

Soundtrack/subtitle language not the one selected with the SETUP menus.

No subtitles.

Angle cannot be changed.

You have forgotten your ratings password.

≥Insert the disc correctly with the label facing up. (page 20)

≥This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and MP3 disc. (page 10)

≥The disc is dirty. Clean it. (page 69)

≥The disc may be badly scratched. (page 69) ≥You inserted a blank DVD-RAM or DVD-R.

≥If “ ” appears on the television,

the operation is prohibited by the unit or disc.

≥If the unit is not operating at all, press [ , TIMER] (12) to switch the unit to standby, then press [ , TIMER] (12) again to turn the unit on. The unit may not be operating correctly due to lightning, static electricity, or some other external factor.

≥The Child Lock function is activated. (page 54)

≥Some titles and chapters on DVD-Video are not played when you have changed the ratings level. (page 62)

≥Some distortion is normal.

≥The languages are not recorded on the disc.

≥You may have to use the disc’s menus to select languages.

≥The language is not recorded on the disc. (page 59)

≥Subtitles are not recorded on the disc. ≥Turn the subtitles on. (page 51)

≥This function depends on software availability. Angles can only be changed during scenes where different angles are recorded (“ ” appears on the display).

≥Return the unit's settings to the initial state (factory setting).

With the tray open, keep pressing [:/6] and [5/9] (45) on the main unit simultaneously for 5 or more seconds.

Remote control

The remote control doesn’t work.

Cannot operate the television.

≥The unit is on standby to make a timer recording (“ ” on the unit’s display is on). (page 32) ≥[DVD, TV] (15) is not switched to “DVD”.

Switch to “DVD” when operating this unit. (page 8) ≥The remote control code is wrong.

Change to the correct code. (page 63)

≥The batteries are depleted. Replace them with new ones. (page 8)

≥Point the remote control at the remote control sensor on the main unit. (page 8) ≥Remove obstacles from between the remote control and main unit.

≥The Child Lock function is activated. (page 54)

≥The remote control code is wrong.

Change to the correct code. Some televisions cannot be operated even if you change the code. (page 9)

≥[DVD, TV] (15) is not switched to “TV”.

Switch to “TV” when operating the television. (page 9)

75