Panasonic CQ-DX200W manual Safety Information English

Page 3

Caution

Observe the following cautions when using this unit.

Keep the sound volume at an appropriate level.

Keep the volume level low enough to be aware of road and traffic conditions while driving.

This unit is designed for use exclusively in automo- biles.

Do not operate the unit for a prolonged period with the engine turned off.

Operating the audio system for a long period of time with the engine turned off will drain the battery.

Do not expose the unit to direct sunlight or exces- sive heat.

Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.

Do not use the product where it is exposed to water, moisture, or dust.

Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days.

Set the volume level to low enough before the AUX connection is completed.

Failure to observe this, the loud noise may come out and damage your speakers and your hearing. Direct connection of the speaker/headphone output of an external device with- out any attenuator may distort sound or damage the con- nected external device.

Observe the following cautions when installing.

Refer wiring and installation to qualified service personnel.

Installation of this unit requires special skills and experience. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit.

Follow the instructions to install and wire the prod- uct.

Not following the instructions to properly install and wire the product could cause an accident or fire.

Take care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.

Use the designated parts and tools for installation.

Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those sup- plied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunction or fire.

Do not block the air vent or the cooling plate of the unit.

Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.

Do not install the product where it is exposed to strong vibrations or is unstable.

Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.

Installation Angle

The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚.

The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details.

Wear gloves for safety. Make sure that wiring is completed before installation.

To prevent damage to the unit, do not connect the power connector until the whole wiring is complet- ed.

Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

Observe the following cautions when handling the battery for the remote control unit.

Use only specified battery (CR2025).

Match the polarity of the battery with the (+) and (–) marks in the battery case.

Replace dead battery as soon as possible.

Remove the battery from the remote control unit when not using it for an extended period of time.

Insulate the battery (by placing them in a plastic bag or cov- ering them with vinyl tape) before disposal or storage.

Dispose of the battery according to the local regulations.

Do not disassemble, recharge, heat or short the battery. Do not throw a battery into a fire or water.

In case of battery leakage

Thoroughly wipe the battery liquid off the battery case and insert new battery.

If any part of your body or clothing comes into contact with battery liquid, wash it with plenty of water.

If battery liquid comes into contact with your eyes, wash them with plenty of water and get immediate medical atten- tion.

Observe the following cautions when using USB devices.

Do not connect a USB device directly to this unit. If a device is connected directly to this unit and an accident occurs, or if the brakes are applied suddenly, the driver or passenger may bump into the USB device and may be injured.

Connect your USB device to your car audio using a standard USB extension cable (5 m or less).

Position the USB device and USB extension cable so that they do not interfere with your driving.

Do not connect any USB device other than a USB memory or a USB audio player. Do not connect multiple USB devices to the USB connector. Supplying power to multiple USB devices from the connector could cause overheating and smoking.

Safety Information English

CQ-DX200W3

Image 3
Contents DVD Player/receiver Safety Information Safety Information English Safety Information Models CQ-DX200W3 CQ-DX200W5 Features Before Reading These InstructionsDifferences between 2 Models Qty AccessoriesInstallation Instructions Operating InstructionsBefore Reading These Instructions, Features English FeaturesDiscs that can be Played Back Contents Main Unit Controls LayoutControls Layout English GeneralDiscs DVD/VCD/CD/MP3/DivX Battery Replacement PreparationPreparation Before Initial Use Press Disp TV Type settingClock adjustment Press Disp Adjust the minuteGeneral Removing/MountingPlate General English Temporary Volume Off Down Clock Display at Power OffVolume off down CancelPlayer BluetoothSystem-up Connector RadioGeneral English Adjustment Selection Based on GenreSQ changeover Radio Operation Flow Radio Mode DisplayFrequency adjustment Preset station selectionPreset Station Calling Station PresetAuto Preset Memory APM Manual station presetTrack selection CD Mode DisplayCD Player Operation FlowCD Player Functions Only by Remote Control UnitPause Folder selection MP3/DivX PlayerPlayer File selectionFolder Random Play Folder Repeat Play PlayMP3/DivX Player Random Play Repeat PlayWhat is MP3/DivX? Setting at file makingFiles Copyright No warrantyCommon Compressed audio file writingDVD/VCD Player FlowMode Direct Selection during playback DVD/VCD PlayerDisc Menu DVD Title Menu DVDDisplay the unit’s registration code About DivX VOD contentAngle DVD Subtitle DVD DivXRange Compression DVD Audio VCDDivX OSD On-Screen DisplayOSD On-Screen Display CD Music CDText off Chapter play time DVD DVD Video VCD Video CDDisconnect the USB memory and USB extension cable USB DisconnectUnit Folder Random PlayFolder Scan Play Select to display the Audio menu display Audio SettingPress Push SEL Select to select a mode to be adjusted Press Push SELHold down VOL Function SettingAudio Setting, Function Setting Function Menu DisplaySetup Menu display User SettingsUser Language Code List Language code. See belowCode Language Name Check the wiring TroubleshootingLanguage Code List, Troubleshooting Problem No power to Unit Sound is not Generated NoiseChassis Check the speaker wiringAntenna installation or wiring of antenna cable is faulty Check the wiring of the antenna battery leadSecure the unit to the console box TroubleshootingNo playback or Disc ejected Sound skipping or Noise Disc unejectableCompressed audio Remote control unitBattery is weak Aiming direction of the remote control unit is wrongConnect cables correctly Picture Appears IncorrectlyNo subtitles Appear It is difficult to Problem Video CD menu Playback does not WorkCannot switch Audio Language/subtitle Language/angle DVD/VCDDisplay Error Display MessagesCD/Compressed Audio DivX VOD displayed on Connected monitorMaintenance/Fuse Nearest authorized Panasonic Service CenterFuse How to hold the disc Disc cleaningPlayable System Upgrade Sample Connectable Devices System Upgrade Sample, GeneralTrack/File selection Operation Flow CD Changer Mode DisplayDisc selection Folder up/downDisc Random Only for CD changer Direct AccessDisplay Folder Repeat Only for MP3 discOperation Flow DVD Changer Mode Display Disc Changer when DVDs or VCDs are loaded¡For a DVD insertion ¡For a VCD insertion LoadedAre IPod Control PlayingFile Selection Pause Songs IPod Mode DisplayControl Play ShuffleMode Select the BT HF mode/BT Audio BluetoothEstablish pairing. a next Press SRC to select the BluetoothBluetooth Press Push SEL Select to select a mode to be adjusted BT Function Menu DisplayPerform each set- ting Disc Changer Verify the wiringIPod Control Bluetooth Definition of Terms AM radio SpecificationsGeneral Disc Player Radio FM stereo radioMemorandom Specifications, MemoWeb Site http//panasonic.net