Panasonic TH-61PHW6 manual Freq kHz / V-FREQ Hz

On-Screen Menu Display from Remote Control CLAMPSIGNALPOSITION [COMPONENT]

Select SIGNAL from the “SET UP” menu during RGB or PC input signal mode.

Press to select each item.

Press to adjust.

Press to select Signal mode.

The following operation methods are the same for both the SIGNAL [RGB] and SIGNAL [PC].

SYNC

Setting RGB sync signal setting:

Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).

H&V: The H and V sync signals are input from the HD/VD (BNC) connector.

ON G: Uses a synchronized signal on the Video G signal, which is input from the G (BNC) connector.

ON VIDEO: Compatible with the scart plug (Europe)

The composite video signal input from the VIDEO input terminal is used by dividing the sync signals.

IGNAL			[RGB]
SYNC
PULL-INRANGE
CLAMPPOSITION		60315.0kHz		[	PC]
IGNAL	VH-FREQ..		H&V
SYNC
PULL-INRANGE
CLAMPPOSITION		60315.0￿kHz
	VH-FREQ..
SYNC			H & V
SYNC			ON G
SYNC		ON VIDEO

Setting PC sync signal setting:

Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT). H&V: The H and V sync signals are input from the HD/VD (BNC) connector.

ON G: Uses a synchronized signal on the Video G signal, which is input from the G (BNC) connector.

PULL IN RANGE

Sets the width for different frequencies.

(This setting is the same for both SIGNAL [RGB] and SIGNAL [PC].)

CLAMP POSITION

Adjusts the clamp position.

The following operation methods are the same for “SIGNAL” menu during COMPONENT, RGB and PC input signal mode.

Normally, these adjustments are set to appropriate levels and, therefore, do not need to be altered.

PULL IN RANGE	NARROW
PULL IN RANGE	WIDE

CLAMP POSITION

H-FREQ (kHz) / V-FREQ (Hz)

Displays the H (Horizontal) / V (Vertical) frequencies.

This display is valid only for RGB input and PC input. Display range:

Horizontal 15.5 - 110 kHz Vertical 48 - 120 Hz

H-FREQ. V-FREQ.

31.5

60.0

kHz Hz

22