Accessories/Options
2 Setting-up
Remove the plasma television unit from its packing box, spread a clean blanket or other covering on a level floor or stand, place the television on the floor or stand with its front panel facing down, and keep it like this until installing it on the pedestal.
Securing the television unit
Television unit
* Carry out work on a horizontal and level surface.
Lift the television unit above the pedestal base, with the back of the television unit on the same side as the Pedestal No. label. Then align the holes in the television unit with the poles of the pedestal and lower the television unit into place. Use the assembly screws B (M5 x 30) to fasten securely.
Pedestal No. label
Rear
Pedestal
3 Stopping the plasma television from falling over
Securing to a base. | Securing to a wall. |
Front
Do not remove this screw.
* Remove the screws at both top corners on the rear side of the plasma TV, and attach the clamps 
to the
plasma TV using the
removed screws. Screws on main body
Front
Wood
Worktop
Fasten with wood screws in the holes in the back edge of the wood worktop. If there are no holes, first drill them in the middle of the thickness of the wood worktop, and then fasten the strap with wood screws.
• Securing method
*Use strong wire or chain which is commercially available to secure the plasma television to a solid area of the wall or a pillar.
* The plasma TV must be fastened to both the base and the wall.
8