Installation
Receiver Location
This unit is intended to be used with the stand or bracket. Consult your dealer for available options. Position for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen. Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or moisture.
Optional External Equipment
The Video/Audio connection between components can be made with shielded video and audio cables. For best performance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply store.
Before you purchase any cables, be sure you know what type of output and input connectors your various components require. Also determine the length of cable you will need.
Remote Control Battery Installation
1. Open the cover. | 2. Install the batteries and replace the cover. |
| Note the correct polarity (+ and |
| Two AA size |
Helpful Hints:
For frequent remote control users, replace old batteries with alkaline batteries for longer life.
Helpful Hints:
Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on page 54, prior to setting up the remote control.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1.Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2.Do not combine a used battery with a new one.
3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4.Do not attempt to charge,
5.Battery replacement is necessary when remote control acts sporadically or stops operating the TV set.
7