Sync, Pull-in range, Clamp position | Panasonic TH-37PW4 specification

Setup for input signals

Select Signal from the “Setup” menu during RGB or PC input signal mode.

Press to select each item.

Press to adjust.

The following operation methods are the same for both the Signal [RGB] and Signal [PC].

Sync

Setting RGB sync signal:

Confirm that the input is set to RGB input (this setting is valid only for RGB input).

H&V:	The H and V sync signals are input from the HD/VD connector.
on G:	Uses a synchronized signal on the Video G signal, which is input

from the G connector.

on VIDEO: Compatible with the scart plug (Europe)

The composite video signal input from the VIDEO input terminal is used by dividing the sync signals.

Signal			[	RGB	]
Sync			H & V
Pull-in	range		Narrow
Clamp position
	H-Freq.	31.5	kHz
	V-Freq.	60.0	Hz

Signal	[	Component	]
Clamp	position

Signal			[	PC	]
Sync			H & V
Pull-in	range		Narrow
Clamp position
	H-Freq.	31.5	kHz
	V-Freq.	60.0	Hz

Sync	H & V
Sync	on G
Sync	on VIDEO

Setting PC sync signal:

Confirm that the input is set to PC input (this setting is valid only for PC input). H&V: The H and V sync signals are input from the HD/VD connector.

on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.

Pull-in range

Sets the width for different frequencies.

Pull-in range

Narrow

(This setting is the same for both Signal [RGB] and Signal [PC].)

Pull-in range

Wide

Clamp position

Adjusts the clamp position.

The following operation methods are the same for “Signal” menu during Component, RGB and PC input signal mode.

Normally, these adjustments are set to appropriate levels and therefore, do not need to be altered.

H-Freq (kHz)/V-Freq (Hz)

Displays the H (Horizontal)/V (Vertical) frequencies.

This display is valid only for RGB input and PC input. Display range:

Horizontal 15.5 - 110 kHz Vertical 48 - 120 Hz

H-Freq. V-Freq.

31.5

60.0

kHz Hz