Panasonic TH-37PW4 operating instructions Sound Adjustment, Mute, Bass, Treble, Balance

Page 24

Sound Adjustment

1 SOUND

Press to display the Sound menu.

2 Select to adjust each item.

Press to select the desired adjustment menu.

Select the desired level by listening to the sound.

INPUT

SURROUND

VOL

NR

PICTURE

SOUND

SET UP

PICTURE

Bass

Adjusts low sounds

Treble

Adjusts high sounds

Balance

Adjusts left and right volumes

Surround (see next page) Select On or Off

Sound
Normalise	Normal
Sound Mode	Normal
Bass	0
Treble	0
Balance	0
Surround	On

Normal

Auto

Emits the original sound.

Automatically controls proper volume level.

•To end adjustments

R

Press the R button

Note:

Press the SURROUND button to directly turn the surround effect On and Off. (see next page)

Helpful Hint ( N / Normalise Normalisation)

While the “Sound” menu is displayed, if either the N button on the remote control is pressed at any time or the (Action button) is pressed during “Normalise”, then all adjustment values are returned to the factory settings.

Mute

Useful when answering the phone or receiving unexpected visitors.

Press this button to mute the sound.

Press again to reactivate sound. Sound is also reactivated when power is turned off or volume level is changed.

24

Image 24

Contents Operating Instructions TH-37PW4 Wide Plasma DisplayEnglish Dear Panasonic Customer Trademark CreditsTable of Contents Important Safety Notice Safety Precautions SetupWhen using the Plasma Display Cleaning and maintenance Safety PrecautionsIf problems occur during use Accessories Accessories SupplyOptional Accessories Check that you have the accessories and items shownRemote Control Batteries Precaution on battery useObserve the following precaution Helpful HintConnections Cable fixing bandsAV Input Terminals connection ConnectionsVideo 4 pin socket Component signals Y, PB, PR connection Component/RGB Input connectionRGB signal R, G, B, HD, VD connection How to connect the PC Input Terminals Signal Names for D-sub 15P ConnectorHow to connect the Serial Terminals CommandCommunication parameters Basic format for control dataBasic Controls Power On/Off and input signal selection Power On/OffConnecting the plug to the Wall Outlet AC cord connectionSelect the input signal Power On/Off and input signal selectionSelecting the On-Screen Menu Language On-Screen Menu Display from Remote Control To Sound adjust menu SeeOn-Screen Menu Display from Remote Control Aspect Controls Aspect Controls ZoomJust PanasonicAdjusting Picture Pos./Size Adjusting screenAdjusting Picture Pos./Size Pos Size Clock Phase RGB/PC in ModeHelpful Hint N / Normalise Normalisation Pos SizeSound Adjustment MuteBass TrebleSurround Controls OffPicture Adjustments NormalDynamic CinemaPicture Adjustments Screensaver For preventing after-images Reversal / Scroll selectionOn / Off selection To stop the Screensaver under On, press the buttonSide Panel Adjustment Setup for input signals Component/RGB-in select3D Y/C Filter For Ntsc video images Setup for input signals Colour system / Panasonic AutoIf the picture image becomes unstable Sync Pull-in rangeClamp position Freq kHz/V-Freq HzTroubleshooting Plasma Display panel Symptoms CheckSpecifications Specifications Customer’ Record