Panasonic TH-37PW4 operating instructions Basic Controls

Basic Controls

		R - STANDBY			INPUT	– VOL +
		G	POWER ON
		TH	-42PW4
Main Power On/Off Switch
					INPUT button
	Power Indicator
				(AV (S Video)/Component, RGB/PC
The Power Indicator will light.
				Mode Selection)
• Power-OFF ..... Indicator not illuminated (The
				Push the “INPUT” button to select AV(S
unit will still consume some power as long as				Video)/Component or RGB/PC input

the power cord is still inserted into the wall	signal modes sequentially.
outlet.)
	(see page 17)
• Stand-by .... Red

•Power-ON ...... Green

Volume Adjustment Push the Volume Up “+” or Down “–button” to increase or decrease the sound volume level.

Stand-by (ON/OFF) button

The Plasma Display must first be plugged into the wall outlet and turned on at the power switch (see page 16). Push this button to turn the Plasma Display On, from Stanby mode. Push it again to turn the Plasma Display Off to Stanby mode.

SURROUND button

(see page 25)

						INPUT button
Status button						(AV(S Video)/Component, RGB/
						PC Mode Selection)
Push the “Status” button to display
						Press to select AV(S Video)/
the current system status.
						Component or RGB/PC input signal
	AV	1
						modes sequentially. (see page 17)
	4 : 3	2
					INPUT
						Sound mute On/Off (see page 24)
				SURROUND		Volume Adjustment
Off timer	90	3
						Press the Volume Up “+” or Down
1 AV(S Video)/Component, RGB/				VOL
						“–button” to increase or decrease
PC mode			N		R	the sound volume level.
2 Aspect mode (see page 20)
						R button
3 Off timer
The off timer indicator is displayed						ACTION button
only when the off timer has been set.
	N button					Press to make selections
(see page 23, 24, 26)						POSITION buttons
			PICTURE	SOUND	SET UP
PICTURE button						SET UP button (see page 18)
(see page 26)						SOUND button (see page 24)
			PICTURE
			POS. /SIZE		ASPECT
PICTURE POS./SIZE button						ASPECT button
(see page 22)						Press to adjust the aspect.
			PC		OFF TIMER	(see page 20)
	PC button
Push the “PC” mode selection
button to select the PC mode.				OFF TIMER button
This button is used to switch
directly to PC mode.			The Plasma Display may be preset to switch to stand-by after a fixed period. The
			setting changes to 30 minutes, 60 minutes, 90 minutes and 0 minutes (off timer
			cancelled) each time the button is pressed.
			When three minutes remain, “Off timer 3” will flash.				30	60	90
			The off timer is cancelled if a power interruption occurs.					0

15