Fisher & Paykel RX256 Ice maker is not, Producing ice, Water filter, Indicator light is, Red

Troubleshooting

Ice and water

43

EN

Problem	Possible causes	What to do
Ice maker is not	Ice maker arm is up.	Confirm ice maker arm is down. See
producing ice.		automatic ice maker, page 23.
	Household water supply is	See connecting the water supply,
	not reaching water valve.	pages 9 – 10.
	Copper tubing has kinks.	Turn off water supply and remove kinks.
		If kinks cannot be removed, replace tubing.
	Water pressure is too low.	Water pressure must be between 35 to 100
		pounds per square inch to function properly.
		A minimum pressure of 35 pounds per
		square inch is recommended for refrigerators
		with water filters.
	Check freezer temperature.	See temperature controls pages 12 or 16 to
		adjust controls. Freezer must be between 0°
		to 2° F (-18° to -17° C) to produce ice.
	Ice bin is not installed	See ice storage bin, page 23.
	properly.
	Improper water valve was	See connecting the water supply,
	installed.	pages 9 – 10. Self-piercing and 3⁄16” (4.7 mm)
		saddle valves cause low water pressure
		and may clog the line over time. The
		manufacturer is not responsible for property
		damage due to improper installation or
		water connection.
Water filter	Water filter needs to be	If filter is not available, replace with bypass
indicator light is	replaced.	cap. See water filter, page 25.
red.
	Filter indicator sensor	See Filter Status Indicator Light,
	needs to be reset.	page 14 or 23.