Connections
PC Input Terminals connection
COMPUTER
AUDIO
PC IN
Conversion adapter |
|
|
(if necessary) |
| |
|
| |
|
| RGB |
|
| PC cable |
Less than | Ferrite core | Less than |
3” 15/16 | (Small size) | 3” 15/16 |
(10 cm) | (supplied) | (10 cm) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Audio |
|
| Stereo plug |
|
|
| ||||
Connect a cable which matches |
| |||||
the audio output terminal on the computer. |
| |||||
Installing the ferrite core (Small size)
1 | 2 | 3 |
|
| Open |
| Pull back the tabs | Press the cable |
| (in two places) | through and close |
Notes:
•Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
•The display resolution is a maximum of 1,024 × 768 dots when the aspect mode is set to “NORMAL”, and 1,366 × 768 dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
•The PC input terminals are
•Some PC models cannot be connected to the set.
•There is no need to use an adapter for computers with DOS/V compatible
•The computer shown in the illustration is for example purposes only.
•Additional equipment and cables shown are not supplied with this set.
•Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input Terminal
Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name |
1 | R (PR/CR) | 6 | GND (Ground) | 11 | GND (Ground) |
2 | G (Y) | 7 | GND (Ground) | 12 | SDA |
3 | B (PB/CB) | 8 | GND (Ground) | 13 | HD/SYNC |
4 | GND (Ground) | 9 | NC (not connected) | 14 | VD |
5 | GND (Ground) | 10 | GND (Ground) | 15 | SCL |
10