Panasonic BT-LH900E Battery holder, Analogue component/RGBS connectors, = SDI output connector

Parts and their functions

@ 5 7 6

Y/G	VIDEO
	IN

PB/BOUT

:

;

PR/R	SDI 1
	IN
SYNC	SDI 2	<
	IN

CONTROL	SWITCHED
	OUT
POWER
GPI

=

>

DC IN

RS-232C

?

@ A 8 9

5Battery holder

This holder is used with a battery made by Anton Bauer.

6Analogue component/RGBS connectors

These are the BNC input connectors for the analogue component (Y/Pb/Pr) or RGBS signals. When RGB signals are supplied, external sync (gen-lock) can also be used.

=SDI output connector

The SDI signals are output from this connector. It is the switched output of the < SDI input connectors.

The signals displayed on the screen, whether they are the ones supplied to the SDI 1 connector or SDI 2 connector, are output.

However, the switched output signals are not output when the component or video input signals have been selected.

7Main controls dedicated connector

The cable from the main controls is connected here.

<Note>

The monitor is shipped with the cable disconnected from the connector. Prior to use, therefore, check out the shape of the cable connector and plug it properly into this connector.

8GPI connector

When GPI signals are connected here, external operations can be performed.

9RS-232C connector

External operations can be performed under the RS- 232C standard.

:VIDEO IN connector

The video input signals are supplied to this connector.

;VIDEO OUT connector

The video signals are output from this connector. Signals are passed through the : VIDEO IN connector and output from this connector.

>Power switch

This is the power switch.

?External DC power socket

The external DC power source is connected here. When a DC power supply is connected concurrently with the battery, the external power input takes precedence.

@Tripod fastening screws

Two screws (UNC3/8-16 compatible) for securing a tripod are provided each on the top of the monitor and at its bottom where the main controls are removed.

A removable screw spacer is provided in one of the screw holes in the bottom of the monitor, and this supports a UNC1/4-20 screw. To secure the tripod, use the hole that fits the diameter of the fastening screw on the tripod.

ALight control switch

This is not used on this monitor.

<SDI input connectors

The SDI input signals are supplied to these connectors which support automatic HD/SD switching.

7