Operation Quick Guide
Operatinon
Operating the projector
1Press "DEVICE"to select the projector, and then press "ENTER".
(Example: When “DVD” is selected)
Learning remote control signals directly from home theatre system devices
Operations can be learnt for buttons one by one.
Note:
Remote control signals that are not
It may not be possible to record some types of signal. There is a limit to the number of buttons that can be learnt. The maximum number will vary depending on the remote control signals that are learnt, but generally the maximum number of keys that can be learnt is about 80.
It may not be possible to learn remote control signals correctly if the remote control's batteries are nearly spent.
Perforation
Alternatively, press any one of the buttons
marked as "Projector | Operation will change from | |
home theatre system | ||
function only". | ||
devices to the projector. |
Operating the home theatre system
1Press "DEVICE", tilt the button to select the device to be operated, and then press "ENTER".
(Example: When “DVD” is selected)
2Press the button for the desired operation.
(Example: When playback is selected)
Note:
At the time of purchase, the remote control is programmed with remote control signals for Panasonic products.
If the devices you are using cannot be operated by using the default settings, refer to “Setting remote control signals
for home theatre systems” 
p.5-)
The default settings for
If device selection is set to "PJ", the home theatre system buttons can be used to operate other home theatre system devices. Refer to "Remote control function list" .
Using the learning function
1Press "LEARN" for 3 seconds or more and then press "ENTER".
2Press "DEVICE"to select the home theatre system device to be set.
(Example: When “DVD” is selected)
3Place the projector’s remote control next to the emitter of the home theatre system’s remote control.
Approx. 5 cm
4Press the button on the projector’s remote control that you would like to learn, and after "LEARNING?" is displayed, press the corresponding button on the home theatre system device’s remote control.
Projector’s | ) | Home theatre system’s | ) |
(remote control | (remote control |
After
5 seconds
( Example: When learning the ) function of the playback button
If “ERROR” is displayed.
To learn another button, repeat step 4.
If an operation macro has been assigned to the function button, signals cannot be learnt for that button.
If “ERROR” is displayed, return to step 4.
5To finish, press "SETUP", and then check operation.
You can tear off this page along the perforation to use it as a quick reference guide.
ENGLISH - 3