Tips on correct learning

Setting remote control signals for home theatre systems

Learning remote control signals directly from home theatre system devices

Operations can be learnt for buttons one by one.

Note:

Remote control signals that are not infrared-type (wave format) signals cannot be recorded.

It may not be possible to record some types of signal. There is a limit to the number of buttons that can be learnt. The maximum number will vary depending on the remote control signals that are learnt, but generally the maximum number of keys that can be learnt is about 80.

It may not be possible to learn remote control signals correctly if the remote control's batteries are nearly spent.

Using the learning function

1Press "LEARN" for 3 seconds or more and then press "ENTER".

2Press "DEVICE"to select the home theatre system device to be set.

(Example: When “DVD” is selected)

3Place the projector’s remote control next to the emitter of the home theatre system’s remote control.

Approx. 5 cm

4Press the button on the projector’s remote control that you would like to learn, and after "LEARNING?" is displayed, press the corresponding button on the home theatre system device’s remote control.

Note:

If the batteries of the remote control are spent, the signals will not be recorded correctly.

If no operations are carried out for 60 seconds or more during learning, the setting mode will be cancelled. To carry out learning correctly, repeat the procedure from step 1.

When function buttons A/B/C have been learnt, “-A-, -B-, -C-” will be displayed, and you can edit the characters that are displayed here.

(p.14)

Do not move the remote control while learning is in progress.

Place fresh batteries into both the projector’s remote control and the other remote control before starting.

Avoid carrying out the procedure in places that are exposed to direct sunlight or lights. (Interference may occur and cause errors in learning.)

The position of the emitter will vary depending on the shape of the remote control. Place the projector’s remote control correctly in front of the emitter, and at a distance of 5 cm.

Projector’s	)	Home theatre system’s	)
(remote control		(remote control

After

5 seconds

( Example: When learning the ) function of the playback button

If “ERROR” is displayed.

To learn another button, repeat step 4.

If an operation macro has been assigned to the function button, signals cannot be learnt for that button.

If “ERROR” is displayed, return to step 4.

5To finish, press "SETUP", and then check operation.

6 - ENGLISH