Panasonic TX-76PW100A, TX-86PW100A Tuning Menu Manual Tune, Tuning the Television to a VCR

Tuning Menu

Manual Tune

This Television has been factory tuned to all the major city channels. Use this tuning procedure only if you wish to reset individual Programme Numbers.

The television should be switched ON and the TV/AV Switch set to TV.

Using the Front Panel					Using the Remote Control
1.	Push the F button repeatedly until the Tuning				1.	Push the Set Up	button.
	Menu is reached.				2.	Push the /\ or \/ button to select the Tuning
2.	Push the - / \/ or + / /\ button to access the					Menu. (See page 27).
	Tuning Menu. (See page 27).				3.	Push the - or + button to access the Tuning
3.	Push the F button to access the Manual					Menu.
	Tune.				4.	Push the /\ or \/ button to select the Manual
4.	Push the - / \/ or + / /\ buttons to select the					Tune.
	Manual Tune.
	MANUAL TUNE (FRONT PANEL)					29
						CH 29
	- , +	:	SEARCH
	TV/AV	:	MOVE CURSOR
	STR	:	TO STORE
	F	:	TO EXIT
	STR	F	-/\/	+//\ TV/AV

5. Push the F button to switch to “Change Programme”.

6.Use the - / \/ or + / /\ buttons to select the

	programme location number to tune.	5.	Push the - or + button to access the Manual
7.	Push the F button to switch to “Search”.		Tune.
8.	Push the - / \/ or + / /\ Button to start the	6.	Push the /\ or \/ button to select the
	search.		programme location number to tune.
9.	The television will automatically search for
		7.	Push the - or + button to start the search.
	the next broadcast signal. As each station is
		8.	The television will automatically search for
	found the search will stop. If you do not want
			the next broadcast signal. As each station is
	this station restart the search.
			found the search will stop. If you do not want
10.	Push the STR to store the selected station.
			this station restart the search.
11.	Push the F button to return the television to
		9.	Push the STR to store the selected station.
	the Tuning Menu.
		10.	Push the Set Up button to return the
12.	To return the television to normal operation
			television to the Tuning menu.
	push the F button repeatedly until the volume
	display appears.

Push the button on the remote control to return the television to normal operation.

Tuning the Television to a VCR

1.Turn the VCR On and either start a known tape playing or set the VCR Test Signal, if fitted, to On (refer to the VCR operating instructions).

2.Repeat steps 2, 3 and 4 of the Manual Tuning procedure above. The television will treat the VCR as if it was a normal television broadcast station.

NOTES:

1.The antenna lead must be connected to the VCR and the VCR RF-Out must be connected to the TV RF-In. Please refer to page 39.

2.The picture and sound quality are usually much better if the VCR is connected using the AV Terminals. Please refer to page 40.

29