Adjusting the projected image
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press Auto on the projector or remote control. Within 3 seconds, the
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image clarity
Sharpen the image by rotating the focus ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, you will need to manually correct it following ONE of these steps.
•Using the remote control
Press | / | on the projector or remote control |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||||
to display the Keystone correction page. Press | to |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||||
correct keystoning at the top of the image. Press |
|
|
|
|
|
|
|
| |||
Press | / . | Press | / . | ||||||||
to correct keystoning at the bottom of the image. | |||||||||||
•Using the OSD menu
1.Press MENU/EXIT and then press 
/
until the DISPLAY menu is highlighted.
2.Press 
to highlight Keystone and press MODE/ENTER. The Keystone correction page displays.
3.Press 
to correct keystoning at the top of the image. Press 
to correct keystoning at the bottom of the image.
