English
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.
When shipped, the
On the main unit ONLY:
To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.
While holding ¢, press 
.
To set it back to the 9 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.
While holding 4, press 
.
Tuning in a Station
1 Press FM/AM.
The unit automatically turns on and tunes in the previously tuned station (either FM or AM.)
•Each time you press the button, the band alternates between FM and AM.
2 Press and hold ¢or 4until the station frequencies start changing continuously in the main display.
•¢: to increase the frequencies.
•4: to decrease the frequencies.
The unit starts searching stations and stops when a station of sufficient signal strength is tuned in.
Ex. An FM station is tuned in.
•If an FM program is broadcast in stereo, the STEREO indicator lights on the display.
To stop during searching, press ¢or 4.
When you repeatedly press ¢or 4
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception.
On the remote control ONLY:
Press FM MODE.
•Each time you press the button, FM reception mode alternates between “STEREO” and “MONO.”
STEREO : Normally select this.
In this mode, you can hear stereo sound when a program is broadcast in stereo. In addition, static noise between stations will be erased while tuning.
MONO : Select this when an FM stereo broadcast is noisy or hard to receive. Reception improves though stereo effect is lost. The MONO indicator lights on the display.
Presetting Stations
You can preset 30 FM and 15 AM stations manually.
In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the remote control ONLY:
1 Tune in the station you want to preset.
• See “Tuning in a Station” to the left.
2 Press SET.
The preset number starts flashing as follows:
•When you select an FM station in step 1
•When you select an AM station in step 1
•The unit always starts from the preset number 1.
