LOREX Technology L15LD400 instruction manual Alarm Setup, Interval Setup

ALARM SETUP

1.CHANNEL - Select a channel for the setup.

2.ALARM INPUT - Set up the Alarm Input type.

•NORMALLY CLOSED - The Alarm is triggered when the circuit is closed (ON).

•NORMALLY OPEN - The Alarm is triggered when the circuit is opened (OFF).

3.DURATION - Setup for the post-alarm recording duration, and the alarm output duration. The duration setting is applied to both functions. The setting range is from 1 second to 99 seconds.

NOTE: Alarm output can be triggered by alarm input and video loss. Motion cannot trigger an alarm output.

INTERVAL SETUP

1.SEQUENCE SCREEN - Full Screen Sequence Interval setup (1~99 SEC).

2.PIP SCREEN - Picture in Picture- setup for the sub-picture’s sequence interval (1~99 SEC).

3.EVENT UPDATE - The Event Update Time prevents the system from recording the event logs from the same event. The event types include A

•Alarm

•Motion

•Video loss.

When an event is triggered, it is possible that the same event type continues to be triggered for a period of time (i.e. Motion starts, then stops for a short period, then starts again).

With the Event Update Time setting, whenever there is an event, the system records the starting time and information of the event in the Event Log, and ignores the following events within the duration set in the Event update time. The setting range of the Event Update time is from 10 seconds to 990 seconds.

Configuration

39