LOREX Technology L15LD400 instruction manual PAN/TILT Setup Speed Setup, Spot Setup

EXTERNAL DEVICE

PAN/TILT SETUP - SPEED SETUP

1.PAN SPEED - Set the PANing speed (0 low ~ 7 high).

2.TILT SPEED - Set the TILTing speed (0 low ~ 7 high).

3.ZOOM SPEED - Set the speed of ZOOM IN/OUT (0 low ~ 7 high).

SPOT SETUP

1.SWITCH INTERVAL - Sets the sequence switching time (01 ~ 99 sec.).

2.ALARM POP UP - When an Alarm is detected, the corresponding channel (connected to the Alarm sensor block) pops up onscreen.

3.MOTION POP UP - Sets the MOTION detection pop-up to ON/OFF.

4.EVENT POP UP DURATION - If ALARM or MOTION events occur concurrently on several channels, then Channel 1 has first priority for onscreen POP UP.

•For example, if an events occurs on Channel 1, Channel 2 and Channel 4 at the same time, Channel 1 pops up. If motion stops on channel 1, then channel 2 pops up for the set duration. If motion occurs on Channel 1 again (within the duration), Channel 2 continues to display. If motion on Channel 1 keeps on going even after the duration, Channel 1 pops up again.

43